From: Karun Eagalapati <karun256@xxxxxxxxx> Sometimes it's observed that we get interrupt/Rx frame when device is already detached from mac80211. In this case couple of error messages are displayed in dmesg log. This patch corrects the order so that disconnection will happen cleanly Signed-off-by: Karun Eagalapati <karun256@xxxxxxxxx> Signed-off-by: Amitkumar Karwar <amit.karwar@xxxxxxxxxxxxxxxxxx> --- drivers/net/wireless/rsi/rsi_91x_sdio.c | 19 ++++++++++++++----- 1 file changed, 14 insertions(+), 5 deletions(-) diff --git a/drivers/net/wireless/rsi/rsi_91x_sdio.c b/drivers/net/wireless/rsi/rsi_91x_sdio.c index ebfd29c..f1ba8ac 100644 --- a/drivers/net/wireless/rsi/rsi_91x_sdio.c +++ b/drivers/net/wireless/rsi/rsi_91x_sdio.c @@ -1026,17 +1026,26 @@ static void rsi_disconnect(struct sdio_func *pfunction) return; dev = (struct rsi_91x_sdiodev *)adapter->rsi_dev; + sdio_claim_host(pfunction); + sdio_release_irq(pfunction); + sdio_release_host(pfunction); + mdelay(10); - dev->write_fail = 2; rsi_mac80211_detach(adapter); + mdelay(10); - sdio_claim_host(pfunction); - sdio_release_irq(pfunction); - sdio_disable_func(pfunction); - rsi_91x_deinit(adapter); + /* Reset Chip */ rsi_reset_chip(adapter); + + /* Resetting to take care of the case, where-in driver is re-loaded */ + sdio_claim_host(pfunction); rsi_reset_card(pfunction); + sdio_disable_func(pfunction); sdio_release_host(pfunction); + dev->write_fail = 2; + rsi_91x_deinit(adapter); + rsi_dbg(ERR_ZONE, "##### RSI SDIO device disconnected #####\n"); + } #ifdef CONFIG_PM -- 2.7.4
