Hi, After laptok ~ # echo 0 > /sys/bus/pci/drivers/iwl4965/0000\:04\:00.0/rf_kill laptok ~ # iwconfig wlan0 txpower on laptok ~ # /etc/init.d/net.wlan0 restart * Service net.wlan0 starting * Service net.wlan0 started laptok ~ # dmesg >dmesg-`uname -r`_`date +%F`.txt I get in dmesg ... iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC ACPI: PCI interrupt for device 0000:04:00.0 disabled HW CONFIG: channel=10 freq=2457 phymode=2 ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 17 (level, low) -> IRQ 17 PM: Writing back config space on device 0000:04:00.0 at offset 1 (was 100102, writing 100106) HW CONFIG: channel=10 freq=2457 phymode=2 ADDRCONF(NETDEV_UP): wlan0: link is not ready HW CONFIG: channel=10 freq=2457 phymode=2 wlan0: Initial auth_alg=0 wlan0: authenticate with AP 00:01:e3:06:00:35 phy0: TX to low-level driver (len=30) FC=0x00b0 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 HW CONFIG: channel=10 freq=2457 phymode=2 wlan0: Initial auth_alg=0 wlan0: authenticate with AP 00:01:e3:06:00:35 phy0: TX to low-level driver (len=30) FC=0x00b0 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 wlan0: RX authentication from 00:01:e3:06:00:35 (alg=0 transaction=2 status=0) wlan0: authenticated wlan0: associate with AP 00:01:e3:06:00:35 phy0: TX to low-level driver (len=50) FC=0x0000 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 wlan0: authentication frame received from 00:01:e3:06:00:35, but not in authenticate state - ignored wlan0: authentication frame received from 00:01:e3:06:00:35, but not in authenticate state - ignored wlan0: RX AssocResp from 00:01:e3:06:00:35 (capab=0x11 status=0 aid=1) wlan0: associated phy0: Added STA 00:01:e3:06:00:35 ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready phy0: TX to low-level driver (len=116) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:00:00:00:16 HW CONFIG: channel=10 freq=2457 phymode=2 wlan0: Initial auth_alg=0 wlan0: authenticate with AP 00:01:e3:06:00:35 phy0: TX to low-level driver (len=30) FC=0x00b0 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 wlan0: RX authentication from 00:01:e3:06:00:35 (alg=0 transaction=2 status=0) wlan0: authenticated wlan0: associate with AP 00:01:e3:06:00:35 phy0: TX to low-level driver (len=56) FC=0x0020 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 wlan0: RX ReassocResp from 00:01:e3:06:00:35 (capab=0x11 status=0 aid=1) wlan0: associated wlan0: association frame received from 00:01:e3:06:00:35, but not in associate state - ignored phy0: TX to low-level driver (len=104) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:ff:42:88:f9 phy0: TX to low-level driver (len=96) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:00:00:00:02 phy0: TX to low-level driver (len=68) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=ff:ff:ff:ff:ff:ff phy0: TX to low-level driver (len=116) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:00:00:00:16 phy0: TX to low-level driver (len=68) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=ff:ff:ff:ff:ff:ff phy0: TX to low-level driver (len=96) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:00:00:00:02 phy0: TX to low-level driver (len=96) FC=0x4108 DUR=0x0102 A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=33:33:00:00:00:02 wlan0: no IPv6 routers present phy0: TX to low-level driver (len=46) FC=0x0040 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 phy0: TX to low-level driver (len=46) FC=0x0040 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 phy0: TX to low-level driver (len=46) FC=0x0040 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 phy0: TX to low-level driver (len=46) FC=0x0040 DUR=0x013a A1=00:01:e3:06:00:35 A2=00:13:e8:42:88:f9 A3=00:01:e3:06:00:35 And my wifi working! Bt, I don't know why my wifi working under 2.6.23 and 2.6.24? W liście datowanym na poniedziałek, 16 czerwca 2008, Zhu Yi pisze: >ZY On Fri, 2008-06-13 at 19:37 +0200, Michał Kudła wrote: >ZY > dmesg-2.6.26-rc5_2008-06-13.txt >ZY >ZY >From this log: >ZY >ZY iwl4965: U iwl4965_radio_kill_sw Manual SW RF KILL set to: RADIO OFF >ZY iwl4965: I iwl4965_rx_card_state_notif Card state received: HW:On >ZY SW:Kill >ZY iwl4965: U iwl4965_mac_config leave - radio disabled >ZY iwl4965: Error sending REPLY_TX_PWR_TABLE_CMD: enqueue_hcmd failed: -5 >ZY iwl4965: U iwl4965_bg_rf_kill Can not turn radio back on - disabled by >ZY SW switch >ZY iwl4965: Error sending REPLY_WEPKEY: enqueue_hcmd failed: -5 >ZY >ZY Your radio is disabled by the software rf_kill switch. Please do a >ZY >ZY $ echo 0 > /sys/bus/pci/drivers/iwl4965/<dev id>/rfkill\:rfkill0/state >ZY >ZY I wonder if you (or some application) did something like a `iwconfig >ZY wlan0 txpower off` so that the radio is disabled. Maybe you can try >ZY `iwconfig wlan0 txpower on`? >ZY >ZY Thanks, >ZY -yi >ZY >ZY -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
