On 24 May 2017 at 14:16, James Hughes <james.hughes@xxxxxxxxxxxxxxx> wrote: > On 24 May 2017 at 14:13, Arend van Spriel <arend.vanspriel@xxxxxxxxxxxx> wrote: >> On 24-05-17 14:50, James Hughes wrote: >>> We are seeing an issue on Raspberry Pi which uses the bcm43430 chip. It's >>> been tested up to 4.9 which still shows the issue (it's been there for some >>> time, > 1yr). I'm trying to find someone who can test on 4.11 as I cannot >>> replicate (The latest kernel we have that works on a Pi) >>> >>> It exhibits as a log entry, and subsequent death of wireless connectivity. >>> >>> "Unknown mailbox data content: 0x40012" >>> >>> Look at the driver code, it appears to be checking the return >>> value from a mailbox (presumably the one to the chip firmware), which >>> has the 0x4 in the top word which shouldn't be there. >>> >>> The driver simply adds a log entry, but otherwise ignores the situation. >>> However, we see wireless failure from this point. >>> >>> Since I believe this value is being returned from the chip, I cannot >>> investigate much further. The public datasheet is of no help. We do appear >>> to be using the latest firmware file. >>> >>> I'm not sure how to proceed on this one. It would be interesting to know >>> under what circumstances that value can be returned from the mailbox. >>> >>> More details can be found at the end of this github issue. >>> >>> https://github.com/raspberrypi/linux/issues/1342 >> >> Hi James, >> >> I looked through the issue on github and it seems you are getting -110 >> (-ETIMEDOUT) on SDIO transfers. This could be a signal integrity issue >> of the SDIO bus signals, which may happen if the RPi3 power supply can >> not provide enough amps. So you could try to replicate it by >> deliberately use a power supply below specs. >> >> I did not get my RPi3 going yet, but I can try next monday or so. Office >> closed due to Ascension day. Do you know what SDIO host controller is >> used on RPi3? I can check myself, but if you know the answer up front >> let me know. >> >> Regards, >> Arend > > Hi Arend, > > It's the one built in to the SoC (the bcm2835) and I believe is an > Arasan device. If you need anything else (HW etc) please let me know. > > I'll try the low power setup you suggest. Might be the reason why I > cannot replicate, I always use decent power supplies. > > James Spent an hour or so trying the low power situation. Got to the point where USB devices were dropping out, but didn't see any SDIO timeouts or mailbox errors in dmesg. Will keep looking though - absence of evidence is not evidence of absence etc etc. James
