The rtl8187 doesn't seem to receive multicast data, which, among other
thinks, make it fail to receive RAs in IPv6 networks.
The cause seems to be that the RTL818X_RX_CONF_MULTICAST flag doesn't
have any effect at all. Fix this issue by setting
RTL818X_RX_CONF_MONITOR instead, which puts the card into monitor mode,
and fixes the problem.
Signed-off-by: Nils Holland <nholland@xxxxxxxxx>
---
The problem and solution have been tested on an rtl8187b (0bda:8197), but
the fix changes behavior on other cards supported by the driver as well
(like non-b 8187's). Due to lack of hardware, I unfortunately cannot say
if the issue exists on these cards in the first place, or if the fix has
any unwanted consequences there.
If people consider it a bad idea to just always put the card into monitor
mode (for example, for performance reasons), I could imagine rewriting this
patch so that a module parameter controls this behavior instead.
drivers/net/wireless/realtek/rtl818x/rtl8187/dev.c | 16 +++++++---------
1 file changed, 7 insertions(+), 9 deletions(-)
diff --git a/drivers/net/wireless/realtek/rtl818x/rtl8187/dev.c b/drivers/net/wireless/realtek/rtl818x/rtl8187/dev.c
index 231f84db9ab0..56a8686cd367 100644
--- a/drivers/net/wireless/realtek/rtl818x/rtl8187/dev.c
+++ b/drivers/net/wireless/realtek/rtl818x/rtl8187/dev.c
@@ -946,8 +946,7 @@ static int rtl8187_start(struct ieee80211_hw *dev)
(7 << 13 /* RX FIFO threshold NONE */) |
(7 << 10 /* MAX RX DMA */) |
RTL818X_RX_CONF_RX_AUTORESETPHY |
- RTL818X_RX_CONF_ONLYERLPKT |
- RTL818X_RX_CONF_MULTICAST;
+ RTL818X_RX_CONF_ONLYERLPKT;
priv->rx_conf = reg;
rtl818x_iowrite32(priv, &priv->map->RX_CONF, reg);
@@ -1319,12 +1318,11 @@ static void rtl8187_configure_filter(struct ieee80211_hw *dev,
priv->rx_conf ^= RTL818X_RX_CONF_FCS;
if (changed_flags & FIF_CONTROL)
priv->rx_conf ^= RTL818X_RX_CONF_CTRL;
- if (changed_flags & FIF_OTHER_BSS)
- priv->rx_conf ^= RTL818X_RX_CONF_MONITOR;
- if (*total_flags & FIF_ALLMULTI || multicast > 0)
- priv->rx_conf |= RTL818X_RX_CONF_MULTICAST;
+ if (*total_flags & FIF_OTHER_BSS ||
+ *total_flags & FIF_ALLMULTI || multicast > 0)
+ priv->rx_conf |= RTL818X_RX_CONF_MONITOR;
else
- priv->rx_conf &= ~RTL818X_RX_CONF_MULTICAST;
+ priv->rx_conf &= ~RTL818X_RX_CONF_MONITOR;
*total_flags = 0;
@@ -1332,10 +1330,10 @@ static void rtl8187_configure_filter(struct ieee80211_hw *dev,
*total_flags |= FIF_FCSFAIL;
if (priv->rx_conf & RTL818X_RX_CONF_CTRL)
*total_flags |= FIF_CONTROL;
- if (priv->rx_conf & RTL818X_RX_CONF_MONITOR)
+ if (priv->rx_conf & RTL818X_RX_CONF_MONITOR) {
*total_flags |= FIF_OTHER_BSS;
- if (priv->rx_conf & RTL818X_RX_CONF_MULTICAST)
*total_flags |= FIF_ALLMULTI;
+ }
rtl818x_iowrite32_async(priv, &priv->map->RX_CONF, priv->rx_conf);
}
--
2.11.1
