Hi all,
Yes sorry, it's a false report related to how we do bisects.
CONFIG_BRCM_TRACING=y
CONFIG_BRCMDBG=y
but DEBUG is not defined.
I think it would help if CONFIG_BRCMDBG set DEBUG
or if some of the tests for DEBUG used CONFIG_BRCMDBG instead.
Arend or Rafał, would you be able to look at this build problem? Kbuild
found the build errors below, apparently a very old issue. It just
blames me now because I moved the driver to a new directory :)
It is a very old issue. The thing is that the issue can not really occur
because we have this:
# common flags
subdir-ccflags-$(CONFIG_BRCMDBG) += -DDEBUG
in drivers/net/wireless/broadcom/brcm80211/Makefile. So no clue what
happens in the "kbuild test robot" scenario.
As an optimization, the robot often does "partial builds" during bisects.
For example, when the error is found in
drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.c
It'll try
make drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.o
And verify the bisect result with
make drivers/net/wireless/broadcom/brcm80211/brcmfmac/
However in this case the whole dir is moved, so both logics failed to
give correct results. We'll check how to improve this. Sorry for the
confusions!
I actually tried to reproduce this with kbuild bot's instructions and
was surprised to see that the build worked ok for me. So the issue is
not that simple.
Hi Kalle,
Here is the old email exchange we had about this [1]. In my opinion this
is a Kbuild issue that needs to be looked into.
Regards,
Arend
[1] http://www.spinics.net/lists/linux-wireless/msg142122.html
Thanks,
Fengguang