On Mon, Jan 16, 2017 at 11:17:44AM +0100, Stanislaw Gruszka wrote:
> On Mon, Jan 16, 2017 at 04:17:58AM +0100, Daniel Golle wrote:
> > @@ -7131,6 +7236,12 @@ static int rt2800_validate_eeprom(struct rt2x00_dev *rt2x00dev)
> > rt2x00_set_field16(&word, EEPROM_NIC_CONF0_RF_TYPE, RF2820);
> > rt2800_eeprom_write(rt2x00dev, EEPROM_NIC_CONF0, word);
> > rt2x00_eeprom_dbg(rt2x00dev, "Antenna: 0x%04x\n", word);
> > + } else if (rt2x00_rt(rt2x00dev, RT5350)) {
> > + rt2x00_set_field16(&word, EEPROM_NIC_CONF0_RXPATH, 1);
> > + rt2x00_set_field16(&word, EEPROM_NIC_CONF0_TXPATH, 1);
> > + rt2x00_set_field16(&word, EEPROM_NIC_CONF0_RF_TYPE, RF3320);
Good catch. This line was probably left over when trying to implement
support for RT5350 based on adding codepaths to RF3320 which ended up
messy... As EEPROM_NIC_CONF0_RF_TYPE aparently isn't used anywhere else
in the code apart from setting rf type which is later on overwritten
for RT5350 anyway. So no need to set it at all. I suggest to simply
drop that line.
>
> Here you set RF3320 ..
> > + rt2x00_eeprom_write(rt2x00dev, EEPROM_NIC_CONF0, word);
> > + rt2x00_eeprom_dbg(rt2x00dev, "Antenna: 0x%04x\n", word);
> > } else if (rt2x00_rt(rt2x00dev, RT2860) ||
> > rt2x00_rt(rt2x00dev, RT2872)) {
> > /*
> > @@ -7265,6 +7376,8 @@ static int rt2800_init_eeprom(struct rt2x00_dev *rt2x00dev)
> > rt2800_eeprom_read(rt2x00dev, EEPROM_CHIP_ID, &rf);
> > else if (rt2x00_rt(rt2x00dev, RT3352))
> > rf = RF3322;
> > + else if (rt2x00_rt(rt2x00dev, RT5350))
> > + rf = RF5350;
>
> and here RF5350. This does not seems to be correct.
>
> Stanislaw
