We should not reset USB_DMA_CFG on rt2800usb_init_registers() as this function is called indirectly from rt2800_enable_radio(). If we do so, we wipe out USB_DMA_CFG settings from rt2800usb_enable_radio(). Signed-off-by: Stanislaw Gruszka <sgruszka@xxxxxxxxxx> --- drivers/net/wireless/ralink/rt2x00/rt2800usb.c | 5 +---- 1 files changed, 1 insertions(+), 4 deletions(-) diff --git a/drivers/net/wireless/ralink/rt2x00/rt2800usb.c b/drivers/net/wireless/ralink/rt2x00/rt2800usb.c index 4b0bb6b..9f61293 100644 --- a/drivers/net/wireless/ralink/rt2x00/rt2800usb.c +++ b/drivers/net/wireless/ralink/rt2x00/rt2800usb.c @@ -341,8 +341,6 @@ static int rt2800usb_init_registers(struct rt2x00_dev *rt2x00dev) rt2x00_set_field32(®, MAC_SYS_CTRL_RESET_BBP, 1); rt2x00usb_register_write(rt2x00dev, MAC_SYS_CTRL, reg); - rt2x00usb_register_write(rt2x00dev, USB_DMA_CFG, 0x00000000); - rt2x00usb_vendor_request_sw(rt2x00dev, USB_DEVICE_MODE, 0, USB_MODE_RESET, REGISTER_TIMEOUT); @@ -353,12 +351,11 @@ static int rt2800usb_init_registers(struct rt2x00_dev *rt2x00dev) static int rt2800usb_enable_radio(struct rt2x00_dev *rt2x00dev) { - u32 reg; + u32 reg = 0; if (unlikely(rt2800_wait_wpdma_ready(rt2x00dev))) return -EIO; - rt2x00usb_register_read(rt2x00dev, USB_DMA_CFG, ®); rt2x00_set_field32(®, USB_DMA_CFG_PHY_CLEAR, 0); rt2x00_set_field32(®, USB_DMA_CFG_RX_BULK_AGG_EN, 0); rt2x00_set_field32(®, USB_DMA_CFG_RX_BULK_AGG_TIMEOUT, 128); -- 1.7.1