The patch "ath10k: allow setting coverage class" was missing a check for
CONFIG_ATH10K_DEBUGFS so it would try to use non-existing struct elements
in some configurations. Fix this by adding the appropriate ifdef.
Signed-off-by: Benjamin Berg <benjamin@xxxxxxxxxxxxxxxx>
---
Sorry, so turns out the kbuild test robot is correct and I forgot the ifdef
to check for CONFIG_ATH10K_DEBUGFS, so here a fixup commit for it.
Other than that everything looks good to me in the pending branch.
Benjamin
drivers/net/wireless/ath/ath10k/hw.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/drivers/net/wireless/ath/ath10k/hw.c b/drivers/net/wireless/ath/ath10k/hw.c
index c52b5f4..e182f09 100644
--- a/drivers/net/wireless/ath/ath10k/hw.c
+++ b/drivers/net/wireless/ath/ath10k/hw.c
@@ -338,8 +338,13 @@ static void ath10k_hw_qca988x_set_coverage_class(struct ath10k *ar,
* set the registers again if the firmware does an internal reset and
* this way we will be notified of the event.
*/
+#ifdef CONFIG_ATH10K_DEBUGFS
fw_dbglog_mask = ar->debug.fw_dbglog_mask;
fw_dbglog_level = ar->debug.fw_dbglog_level;
+#else
+ fw_dbglog_mask = 0;
+ fw_dbglog_level = 0;
+#endif
if (value > 0) {
if (fw_dbglog_level > ATH10K_DBGLOG_LEVEL_WARN)
--
2.9.3
