Signed-off-by: Prameela Rani Garnepudi <prameela.j04cs@xxxxxxxxx>
---
drivers/net/wireless/rsi/rsi_91x_sdio.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/drivers/net/wireless/rsi/rsi_91x_sdio.c b/drivers/net/wireless/rsi/rsi_91x_sdio.c
index 8428858..d958f90 100644
--- a/drivers/net/wireless/rsi/rsi_91x_sdio.c
+++ b/drivers/net/wireless/rsi/rsi_91x_sdio.c
@@ -1,6 +1,8 @@
/**
* Copyright (c) 2014 Redpine Signals Inc.
*
+ * Developers:
+ * Fariya Fathima 2014 <fariya.f@xxxxxxxxxxxxxxxxxx>
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
@@ -128,7 +130,7 @@ static int rsi_issue_sdiocommand(struct sdio_func *func,
}
/**
- * rsi_handle_interrupt() - This function is called upon the occurence
+ * rsi_handle_interrupt() - This function is called upon the occurrence
* of an interrupt.
* @function: Pointer to the sdio_func structure.
*
@@ -183,8 +185,7 @@ static void rsi_reset_card(struct sdio_func *pfunction)
host->ios.timing = MMC_TIMING_LEGACY;
host->ops->set_ios(host, &host->ios);
- /*
- * This delay should be sufficient to allow the power supply
+ /* This delay should be sufficient to allow the power supply
* to reach the minimum voltage.
*/
msleep(20);
@@ -193,8 +194,7 @@ static void rsi_reset_card(struct sdio_func *pfunction)
host->ios.power_mode = MMC_POWER_ON;
host->ops->set_ios(host, &host->ios);
- /*
- * This delay must be at least 74 clock sizes, or 1 ms, or the
+ /* This delay must be at least 74 clock sizes, or 1 ms, or the
* time required to reach a stable voltage.
*/
msleep(20);
@@ -361,6 +361,7 @@ static int rsi_setblocklength(struct rsi_hw *adapter, u32 length)
struct rsi_91x_sdiodev *dev =
(struct rsi_91x_sdiodev *)adapter->rsi_dev;
int status;
+
rsi_dbg(INIT_ZONE, "%s: Setting the block length\n", __func__);
status = sdio_set_block_size(dev->pfunction, length);
@@ -464,6 +465,7 @@ int rsi_sdio_write_register(struct rsi_hw *adapter,
void rsi_sdio_ack_intr(struct rsi_hw *adapter, u8 int_bit)
{
int status;
+
status = rsi_sdio_write_register(adapter,
1,
(SDIO_FUN1_INTR_CLR_REG |
@@ -473,8 +475,6 @@ void rsi_sdio_ack_intr(struct rsi_hw *adapter, u8 int_bit)
rsi_dbg(ERR_ZONE, "%s: unable to send ack\n", __func__);
}
-
-
/**
* rsi_sdio_read_register_multiple() - This function read multiple bytes of
* information from the SD card.
@@ -667,7 +667,7 @@ static int rsi_init_sdio_interface(struct rsi_hw *adapter,
goto fail;
}
- rsi_dbg(INIT_ZONE, "%s: Setup card succesfully\n", __func__);
+ rsi_dbg(INIT_ZONE, "%s: Setup card successfully\n", __func__);
status = rsi_init_sdio_slave_regs(adapter);
if (status) {
--
2.4.11
