On Tue, 2016-07-05 at 17:10 +0300, Luca Coelho wrote: > From: Avraham Stern <avraham.stern@xxxxxxxxx> > > Beacon report radio measurement requires reporting observed BSSs > on the channels specified in the beacon request. If the measurement > mode is set to passive or active, it requires actually performing a > scan (passive or active, accordingly), and reporting the time that > the scan was started and the time each beacon/probe was received > (both in terms of TSF of the BSS of the requesting AP). If the > request mode is table, this information is optional. > In addition, the radio measurement request specifies the channel > dwell time for the measurement. > > In order to use scan for beacon report when the mode is active or > passive, add a parameter to scan request that specifies the > channel dwell time, and add scan start time and beacon received time > to scan results information. > > Supporting beacon report is required for Multi Band Operation (MBO). > > Signed-off-by: Assaf Krauss <assaf.krauss@xxxxxxxxx> > Signed-off-by: David Spinadel <david.spinadel@xxxxxxxxx> > Signed-off-by: Avraham Stern <avraham.stern@xxxxxxxxx> > Signed-off-by: Luca Coelho <luciano.coelho@xxxxxxxxx> > --- Forgot to say, the non-mac80211 driver changes are just compiled- tested. -- Luca. -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
