Hi Luana, > From: linux-wireless-owner@xxxxxxxxxxxxxxx [mailto:linux-wireless- > owner@xxxxxxxxxxxxxxx] On Behalf Of Luana Borgia > Sent: Wednesday, April 20, 2016 11:14 AM > To: linux-wireless@xxxxxxxxxxxxxxx; Avinash Patil > Subject: Fwd: ap + adhoc not working with Mwifiex driver for sd8887 > > Hi, > I've successfully managed to get this driver working in adhoc with olsrd > on mlan0 interface, now I'm trying to add a uap0 working at the same > time, with all this command: > > rfkill unblock wlan > ip link set uap0 down > ip link set mlan0 down > iw dev mlan0 set type ibss > ip link set mlan0 up > iw dev mlan0 ibss join mesh 2437 fe:de:fe:de:fe:de olsrd-start.sh cat > <<EOF > /etc/hostapd.conf ssid=PCM_AP_fede > interface=uap0 > driver=nl80211 > hw_mode=g > channel=6 > EOF > iw phy phy0 interface add uap0 type __ap hostapd /etc/hostapd.conf & > dnsmasq --interface=uap0 --except-interface=lo --bind-interfaces --dhcp- > range=192.168.3.2,192.168.3.10,12h --conf-file=/dev/null ip addr add > 192.168.3.1/24 broadcast 192.168.3.255 dev uap0 > > but I get this error after run the hostapd command: > > [ 4980.201096] IPv6: ADDRCONF(NETDEV_CHANGE): mlan0: link becomes ready > [ 4983.335467] IPv6: ADDRCONF(NETDEV_UP): uap0: link is not ready [ > 4983.358879] mwifiex_sdio mmc0:0001:1: CMD_RESP: cmd 0xb1 error, > result=0x1 > > adhoc is fine, with the above order of command but if I run before > hostapd and than adhoc part than the issue occur in the adhoc part. > > I'm using the firmware > http://git.marvell.com/?p=mwifiex- > firmware.git;a=blob;f=mrvl/sd8887_uapsta.bin;h=165e6c3d34b0c2a630252907a > 7ac4daf6e13c9d5;hb=HEAD > > and the mwifiex from kernel linux 4.1.1 > Thanks for reporting the problem. We have started looking into it. Regards, Amitkumar ��.n��������+%������w��{.n�����{���zW����ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f
