Rajkumar Manoharan <rmanohar@xxxxxxxxxxxxxxxx> writes:
> commit 166de3f1895d ("ath10k: remove supported chain mask") had revealed
> an issue on monitor mode. Configuring NSS upon monitor interface
> creation is causing target assert in all qca9888x and qca6174 firmware.
> Firmware assert issue can be reproduced by below sequence even after
> reverting commit 166de3f1895d ("ath10k: remove supported chain mask").
>
> ip link set wlan0 down
> iw wlan0 set type monitor
> iw phy0 set antenna 7
> ip link set wlan0 up
>
> This issue is originally reported on qca9888 with 10.1 firmware.
>
> Fixes: 5572a95b4b ("ath10k: apply chainmask settings to vdev on creation")
> Reported-by: Janusz Dziedzic <janusz.dziedzic@xxxxxxxxx>
> Signed-off-by: Rajkumar Manoharan <rmanohar@xxxxxxxxxxxxxxxx>
Applied, thanks for fixing this. I also CCed stable.
But I'm not actually sure if the "Fixes" lines implies "Cc stable"? I
think I saw one patch going into stable like that so I have been
wondering how this works. Does anyone know?
--
Kalle Valo--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
