ath10k is using Native WiFi mode as default mode for both of Tx and Rx path, but it could be changed when driver registers with a module parameter for specific purpose such as mesh. The Rx decap mode sent to firmware during WMI initialization should use the same mode that driver configured at its registration stage in case of using raw mode, so that host driver receives MAC frame header containing necessary fields such as QoS and Mesh Control and uses them in right way to make data traffic work. Signed-off-by: Peter Oh <poh@xxxxxxxxxxxxxxxx> --- drivers/net/wireless/ath/ath10k/wmi.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c index 87d9de2..78da56c 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.c +++ b/drivers/net/wireless/ath/ath10k/wmi.c @@ -5090,7 +5090,7 @@ static struct sk_buff *ath10k_wmi_10_4_op_gen_init(struct ath10k *ar) config.rx_timeout_pri[2] = __cpu_to_le32(TARGET_10_4_RX_TIMEOUT_LO_PRI); config.rx_timeout_pri[3] = __cpu_to_le32(TARGET_10_4_RX_TIMEOUT_HI_PRI); - config.rx_decap_mode = __cpu_to_le32(TARGET_10_4_RX_DECAP_MODE); + config.rx_decap_mode = __cpu_to_le32(ar->wmi.rx_decap_mode); config.scan_max_pending_req = __cpu_to_le32(TARGET_10_4_SCAN_MAX_REQS); config.bmiss_offload_max_vdev = __cpu_to_le32(TARGET_10_4_BMISS_OFFLOAD_MAX_VDEV); -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
