Search Linux Wireless

Re: [PATCH] ath10k: fix ldpc param for fixed rate

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 16 September 2015 at 09:49, Rajkumar Manoharan
<rmanohar@xxxxxxxxxxxxxxxx> wrote:
> ldpc is not configured for fixed rates. This blocks auto rate vs fixed
> rate performance comparison. Since firmware is considering ldpc vdev
> param for fixed rate selection, it has to be configured to enable ldpc
> for fixed rates.
>
> Signed-off-by: Rajkumar Manoharan <rmanohar@xxxxxxxxxxxxxxxx>
> ---
[...]
> @@ -6041,6 +6049,7 @@ static int ath10k_mac_op_set_bitrate_mask(struct ieee80211_hw *hw,
>         band = def.chan->band;
>         ht_mcs_mask = mask->control[band].ht_mcs;
>         vht_mcs_mask = mask->control[band].vht_mcs;
> +       ldpc = !!(ar->ht_cap_info & WMI_HT_CAP_LDPC);

Is still really correct? LDPC must be supported on the Rx side of
destination stations hence I would assume you need to check whether
all stations associated are LDPC capable before enabling it (e.g. via
ieee80211_iterate_stations_atomic).


Michał
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux