On 2015-08-06 20:45, Peter Oh wrote: > > On 08/06/2015 12:59 AM, Felix Fietkau wrote: >> On 2015-08-06 09:43, Vasanthakumar Thiagarajan wrote: >>> On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote: >>>> On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote: >>>>> Add vendor/device id of QCA99X0 V2.0 to pci id table and >>>>> QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for >>>>> QCA99X0 to get detected by the driver. >>>>> >>>>> Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@xxxxxxxxxxxxxxxx> >>>> I just tested a 99X0 card, and I'm getting this: >>>> >>>> [ 8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142) >>>> [ 8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1 >> irq_mode 0 reset_mode 0 >>>> [ 11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized >> event from target: 00000000 >>>> [ 11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after >> cold reset: -110 >>>> [ 11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110 >>>> [ 11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110 >>>> >>>> This is on an AP148 board with Linux 3.18, backports generated from >>>> latest wireless-testing (2015-08-03) + all patches from kvalo's ath >>>> tree. >>> Any idea about the version of AP148 that you are using?. By any chance >> did >>> you check if QCA988X is working on the same board?. >> No idea about the version, but QCA988X is working in the same slot. > QCA99X0 uses a different version of firmware from QCA988X. > Could you verify which firmware version or file name is using? ath10k/QCA99X0/hw2.0/firmware-5.bin_10.4.1.00007-1 from git is /lib/firmware/ath10k/QCA99X0/hw2.0/firmware-5.bin on the device. However, this error shows up even before it gets to the point of loading the firmware. - Felix -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
