I'm trying this hostapd config file. Beacons seem OK, and station associates. Station puts DHCP Discover on the air (using 20Mhz according to wireshark). AP reads this, and thinks it is sending a DHCP response back, but sniffer never shows DHCP response on the air. Kernel is 4.0.4+, ath10k firmware is CT firmware, 10.1.467 based. I am curious if anyone else has tried to do this? Thanks, Ben interface=vap50 driver=nl80211 logger_syslog=-1 logger_syslog_level=2 logger_stdout=-1 logger_stdout_level=2 ctrl_interface=/var/run/hostapd ctrl_interface_group=0 ssid=ben-ota-2a bssid=04:f0:21:98:d2:34 country_code=US ieee80211d=0 ieee80211h=0 ieee80211w=0 hw_mode=a ieee80211n=1 ieee80211ac=1 beacon_int=240 dtim_period=2 max_num_sta=2007 rts_threshold=2347 fragm_threshold=2346 preamble=0 macaddr_acl=0 auth_algs=1 ignore_broadcast_ssid=0 # Enable HT modes if you want 300Mbps+ throughput. #ht_capab=[HT20][HT40-][HT40+][GF][SHORT-GI-20][SHORT-GI-40] # [TX-STBC][RX-STBC123][MAX-AMSDU-7935][DSSS_CCK-40][PSMP][LSIG-TXOP-PROT] ht_capab=[HT20][HT40+][SHORT-GI-40][SHORT-GI-20] vht_capab=[MAX-MPDU-11454][RXLDPC][TX-STBC-2BY1][RX-STBC-1][MAX-A-MPDU-LEN-EXP0][RX-ANTENNA-PATTERN][TX-ANTENNA-PATTERN] wmm_enabled=1 wmm_ac_bk_cwmin=4 wmm_ac_bk_cwmax=10 wmm_ac_bk_aifs=7 wmm_ac_bk_txop_limit=0 wmm_ac_bk_acm=0 wmm_ac_be_aifs=3 wmm_ac_be_cwmin=4 wmm_ac_be_cwmax=10 wmm_ac_be_txop_limit=0 wmm_ac_be_acm=0 wmm_ac_vi_aifs=2 wmm_ac_vi_cwmin=3 wmm_ac_vi_cwmax=4 wmm_ac_vi_txop_limit=94 wmm_ac_vi_acm=0 wmm_ac_vo_aifs=2 wmm_ac_vo_cwmin=2 wmm_ac_vo_cwmax=3 wmm_ac_vo_txop_limit=47 wmm_ac_vo_acm=0 ### TX queue parameters tx_queue_data3_aifs=7 tx_queue_data3_cwmin=15 tx_queue_data3_cwmax=1023 tx_queue_data3_burst=0 tx_queue_data2_aifs=3 tx_queue_data2_cwmin=15 tx_queue_data2_cwmax=63 tx_queue_data2_burst=0 tx_queue_data1_aifs=1 tx_queue_data1_cwmin=7 tx_queue_data1_cwmax=15 tx_queue_data1_burst=3.0 tx_queue_data0_aifs=1 tx_queue_data0_cwmin=3 tx_queue_data0_cwmax=7 tx_queue_data0_burst=1.5 vht_oper_centr_freq_seg0_idx=38 vht_oper_chwidth=0 channel=36 supported_rates=10 20 55 110 60 90 120 180 240 360 480 540 ieee8021x=0 eapol_key_index_workaround=0 eap_server=0 own_ip_addr=127.0.0.1 # Error emulation settings. ignore_probe_probability=0.000000 ignore_auth_probability=0.000000 ignore_assoc_probability=0.000000 ignore_reassoc_probability=0.000000 corrupt_gtk_rekey_mic_probability=0.000000 -- Ben Greear <greearb@xxxxxxxxxxxxxxx> Candela Technologies Inc http://www.candelatech.com -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
