Some of of qca988x solutions are having global reset issue
during target initialization. Bypassing PLL setting before
downloading firmware and letting the SoC run on REF_CLK is fixing
the problem. Corresponding firmware change is also needed to set
the clock source once the target is initialized. Since 10.2.4
firmware is having this ROM patch, applying skip_clock_init only
for 10.2.4 firmware versions.
Signed-off-by: Rajkumar Manoharan <rmanohar@xxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/core.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index 310e12b..3119192 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -797,6 +797,20 @@ static int ath10k_download_cal_data(struct ath10k *ar)
ar->cal_mode = ATH10K_CAL_MODE_OTP;
done:
+ if ((ar->hw_rev != ATH10K_HW_QCA988X) ||
+ (ar->wmi.op_version != ATH10K_FW_WMI_OP_VERSION_10_2_4)) {
+ ath10k_dbg(ar, ATH10K_DBG_BOOT,
+ "boot using calibration mode %s\n",
+ ath10k_cal_mode_str(ar->cal_mode));
+ return 0;
+ }
+
+ ret = ath10k_bmi_write32(ar, hi_skip_clock_init, 1);
+ if (ret) {
+ ath10k_err(ar, "could not write skip_clock_init (%d)\n", ret);
+ return ret;
+ }
+
ath10k_dbg(ar, ATH10K_DBG_BOOT, "boot using calibration mode %s\n",
ath10k_cal_mode_str(ar->cal_mode));
return 0;
--
2.2.2
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
