From: Eran Harary <eran.harary@xxxxxxxxx> The driver loads the 2 CPU sections, then it needs to let the firmware know to start the authentication of the sections. This is done by writing the relevants bits to FH_UCODE_LOAD_STATUS. For CPU1, the driver sets the lower 16 bits. For both CPUs, the driver sets all the 32 bits. Signed-off-by: Eran Harary <eran.harary@xxxxxxxxx> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx> --- drivers/net/wireless/iwlwifi/pcie/trans.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/drivers/net/wireless/iwlwifi/pcie/trans.c b/drivers/net/wireless/iwlwifi/pcie/trans.c index 49e3206..1ff8767 100644 --- a/drivers/net/wireless/iwlwifi/pcie/trans.c +++ b/drivers/net/wireless/iwlwifi/pcie/trans.c @@ -722,6 +722,11 @@ static int iwl_pcie_load_cpu_sections_8000b(struct iwl_trans *trans, *first_ucode_section = last_read_idx; + if (cpu == 1) + iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFF); + else + iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFFFFFF); + return 0; } @@ -911,9 +916,6 @@ static int iwl_pcie_load_given_ucode_8000b(struct iwl_trans *trans, if (trans->dbg_dest_tlv) iwl_pcie_apply_destination(trans); - /* Notify FW loading is done */ - iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFFFFFF); - /* wait for image verification to complete */ ret = iwl_poll_prph_bit(trans, LMPM_SECURE_BOOT_CPU1_STATUS_ADDR_B0, LMPM_SECURE_BOOT_STATUS_SUCCESS, -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
