Experienced firmware crashed in 636 firmware immediately after
bringing up the AP interface.
The partial log is listed here:
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 33 value 0
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 48 value 1
[ 290.350000] ath10k_pci 0000:00:00.0: wmi peer create vdev_id 0
peer_addr 04:f0:21:0c:a5:43
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set param 13 value 50
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 40 value 3747
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 41 value 3895
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 42 value 3900
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 1 value -1
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 2 value -1
[ 290.350000] ath10k_pci 0000:00:00.0: mac txpower 17
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set param 3 value 34
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set param 4 value 34
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set wmm params
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set wmm params
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set wmm params
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set wmm params
[ 290.350000] ath10k_pci 0000:00:00.0: mac config channel 5180MHz
flags 0x120 radar 0
[ 290.350000] ath10k_pci 0000:00:00.0: mac monitor recalc started? 0 should? 0
[ 290.350000] ath10k_pci 0000:00:00.0: mac monitor recalc started? 0 should? 1
[ 290.350000] ath10k_pci 0000:00:00.0: WMI vdev create: id 1 type 4
subtype 0 macaddr 04:f0:21:0c:a5:43
[ 290.350000] ath10k_pci 0000:00:00.0: mac monitor vdev 1 created
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev start id 0x1 flags:
0x0, freq 5180, mode 10, ch_flags: 0xA000000, max_power: 34
[ 290.350000] ath10k_pci 0000:00:00.0: WMI_VDEV_START_RESP_EVENTID
[ 290.350000] ath10k_pci 0000:00:00.0: wmi mgmt vdev up id 0x1 assoc
id 0 bssid 04:f0:21:0c:a5:43
[ 290.350000] ath10k_pci 0000:00:00.0: mac monitor vdev 1 started
[ 290.350000] ath10k_pci 0000:00:00.0: mac monitor started
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 3 value 100
[ 290.350000] ath10k_pci 0000:00:00.0: mac vdev 0 beacon_interval 100
[ 290.350000] ath10k_pci 0000:00:00.0: vdev 0 set beacon tx mode to staggered
[ 290.350000] ath10k_pci 0000:00:00.0: wmi pdev set param 7 value 0
[ 290.350000] ath10k_pci 0000:00:00.0: mac vdev 0 start center_freq
5180 phymode 11ac-vht80
[ 290.350000] ath10k_pci 0000:00:00.0: wmi vdev start id 0x0 flags:
0x0, freq 5180, mode 10, ch_flags: 0xA000000, max_power: 34
[ 291.330000] ath10k_pci 0000:00:00.0: wmi event debug mesg len 36
[ 291.350000] ath10k_pci 0000:00:00.0: firmware crashed! (uuid
ca777c3c-e580-4237-824a-8da65949870b)
[ 291.360000] ath10k_pci 0000:00:00.0: qca988x hw2.0 (0x4100016c,
0x043202ff) fw 999.999.0.636 api 2 htt 2.1 wmi 1 cal otp max_sta 16
[ 291.370000] ath10k_pci 0000:00:00.0: debug 1 debugfs 1 tracing 1
dfs 1 testmode 0
[ 291.380000] ath10k_pci 0000:00:00.0: firmware register dump:
[ 291.380000] ath10k_pci 0000:00:00.0: [00]: 0x4100016C 0x00000000
0x009C4521 0x00000000
[ 291.390000] ath10k_pci 0000:00:00.0: [04]: 0x009C4521 0x00060330
0x00000019 0x00955A00
[ 291.400000] ath10k_pci 0000:00:00.0: [08]: 0x00046A4E 0x00000000
0x0040CC94 0x00000020
[ 291.410000] ath10k_pci 0000:00:00.0: [12]: 0x00000000 0x00000000
0x00958360 0x0095836B
[ 291.420000] ath10k_pci 0000:00:00.0: [16]: 0x809A0978 0x0040AD94
0x00439304 0x0040D074
[ 291.420000] ath10k_pci 0000:00:00.0: [20]: 0x0000FFFF 0x00000000
0x0041B618 0x00000000
[ 291.430000] ath10k_pci 0000:00:00.0: [24]: 0x809A0978 0x0040AD94
0x00439304 0x11A93B77
[ 291.440000] ath10k_pci 0000:00:00.0: [28]: 0x809AD1A2 0x0040ADE4
0x00439304 0x0043F68C
[ 291.450000] ath10k_pci 0000:00:00.0: [32]: 0x00000001 0x00000000
0x00000000 0x00430D74
[ 291.460000] ath10k_pci 0000:00:00.0: [36]: 0x00000000 0x00000000
0x00000000 0x00000000
[ 291.460000] ath10k_pci 0000:00:00.0: [40]: 0x00000000 0x00000000
0x000000AB 0x00412700
[ 291.470000] ath10k_pci 0000:00:00.0: [44]: 0x00439BB8 0x00000000
0x00000000 0x00400000
[ 291.480000] ath10k_pci 0000:00:00.0: [48]: 0x809AE0B4 0x0040AE04
0x00400000 0x0043F68C
[ 291.490000] ath10k_pci 0000:00:00.0: [52]: 0x00000001 0x00000000
0x004231F0 0x00400000
[ 291.500000] ath10k_pci 0000:00:00.0: [56]: 0x809AE17E 0x0040AE44
0x0040FE6C 0x0040D310
[ 291.510000] ath10k_pci 0000:00:00.0: wmi mgmt vdev up id 0x0 assoc
id 0 bssid 04:f0:21:0c:a5:43
[ 291.510000] ath10k_pci 0000:00:00.0: mac vdev 0 up
[ 291.510000] ath10k_pci 0000:00:00.0: mac vdev 0 cts_prot 0
[ 291.510000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 44 value 0
[ 291.510000] ath10k_pci 0000:00:00.0: mac vdev 0 slot_time 2
[ 291.510000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 7 value 2
[ 291.510000] ath10k_pci 0000:00:00.0: mac vdev 0 preamble 1n
[ 291.510000] ath10k_pci 0000:00:00.0: wmi vdev id 0x0 set param 8 value 1
[ 291.510000] ath10k_pci 0000:00:00.0: mac vdev_id 0 txpower 17
---
Chun-Yeow
On Tue, Jan 20, 2015 at 12:36 PM, Ben Greear <greearb@xxxxxxxxxxxxxxx> wrote:
>
>
> On 01/19/2015 01:13 AM, Michal Kazior wrote:
>>
>> The 999.999.0.636 firmware seems to support
>> concurrent IBSS + AP/STA. At least basic stuff
>> works so enable it since some people are
>> interested in this stuff.
>>
>> If it's broken we can fix, restrict or disable it
>> later.
>>
>> Signed-off-by: Michal Kazior <michal.kazior@xxxxxxxxx>
>> ---
>> Hi Martin,
>>
>> Feel free to take this patch and run whatever case
>> you had in mind. If this proves to work for you
>> without any major issues (like notorious crashes,
>> traffic issues and such) I guess we could try
>> pulling this upstream.
>>
>> Make sure you use 999.999.0.636 firmware. The 10.x
>> doesn't support IBSS at all.
>
>
> Likely my 10.1.467 based CT firmware will support this as well...
>
> Ben
>
>>
>>
>> drivers/net/wireless/ath/ath10k/mac.c | 4 ++++
>> 1 file changed, 4 insertions(+)
>>
>> diff --git a/drivers/net/wireless/ath/ath10k/mac.c
>> b/drivers/net/wireless/ath/ath10k/mac.c
>> index 9524bc5..11170ce 100644
>> --- a/drivers/net/wireless/ath/ath10k/mac.c
>> +++ b/drivers/net/wireless/ath/ath10k/mac.c
>> @@ -5032,6 +5032,10 @@ static const struct ieee80211_iface_limit
>> ath10k_if_limits[] = {
>> .max = 7,
>> .types = BIT(NL80211_IFTYPE_AP)
>> },
>> + {
>> + .max = 1,
>> + .types = BIT(NL80211_IFTYPE_ADHOC)
>> + },
>> };
>>
>> static const struct ieee80211_iface_limit ath10k_10x_if_limits[] = {
>>
>
> --
> Ben Greear <greearb@xxxxxxxxxxxxxxx>
> Candela Technologies Inc http://www.candelatech.com
>
>
> _______________________________________________
> ath10k mailing list
> ath10k@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/ath10k
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
