Per-vif bss_conf.ps should be used to configure powersave. Signed-off-by: Michal Kazior <michal.kazior@xxxxxxxxx> --- drivers/net/wireless/ath/ath10k/mac.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 2804952..19ddbc6 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -1099,9 +1099,6 @@ static int ath10k_mac_vif_recalc_ps_poll_count(struct ath10k_vif *arvif) return 0; } -/* - * Review this when mac80211 gains per-interface powersave support. - */ static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif) { struct ath10k *ar = arvif->ar; @@ -1117,7 +1114,7 @@ static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif) if (arvif->vif->type != NL80211_IFTYPE_STATION) return 0; - if (conf->flags & IEEE80211_CONF_PS) { + if (vif->bss_conf.ps) { psmode = WMI_STA_PS_MODE_ENABLED; param = WMI_STA_PS_PARAM_INACTIVITY_TIME; @@ -3378,6 +3375,13 @@ static void ath10k_bss_info_changed(struct ieee80211_hw *hw, ath10k_warn(ar, "failed to recalc tx power: %d\n", ret); } + if (changed & BSS_CHANGED_PS) { + ret = ath10k_mac_vif_setup_ps(arvif); + if (ret) + ath10k_warn(ar, "failed to setup ps on vdev %i: %d\n", + arvif->vdev_id, ret); + } + mutex_unlock(&ar->conf_mutex); } -- 1.8.5.3 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html