Hi Jouni, For the brcmfmac we started working on Multiple-BSSID support and came across some issues with hostapd that are listed listed below. BSS1 setup on netdev wlan0 BSS2 setup on netdev wlan0_0 * get_station() done on wrong netdev observed: Upon association of STA1 with BSS2 (wlan0_0) a get_station() is done for STA1 with wlan0 as netdev. expected: get_station() for STA1 with wlan0_0 as netdev. We verified that wlan0_0 ifindex was used in NL80211_CMD_NEW_STATION event. * cleanup of wlan0_0 not done upon terminating hostapd observed: Upon terminating hostapd, only change interface from AP->STA is received for wlan0_0 and wlan0. The stop_ap is only done for BSS1. So ending up with additional netdev, ie. wlan0_0. expected: following sequence seems more appropriate: stop_ap() for BSS2 if_remove() for BSS2 stop_ap() for BSS1 if_change() AP->STA for BSS1 Do you think it makes sense to correct these scenarios according the described expected behaviour? Maybe the behaviour is only expected by me and there is a good reason for the current behaviour. Regards, Arend -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
