I tried to make my X30 use wireless today and found that its 5.2.19 firmware did not support WPA (scan results were fine). Put the card in another laptop with Windows, installed Cisco driver, that automatically upgraded the firmware to 5.60.21. Now the driver seems to think WPA is working. Scan results are also still there. But trying to enable the MAC on association gets an error like below (cmd 1 s MAC enable, 2 is MAC disable). Googling around shows that people have had this problem already with 5.41 firmware and I saw no solution to it. Are there any docs on firmware interfaces, or was it just reverse engineered - does anybody remmeber? [ 4.610572] airo(): Probing for PCI adapters [ 4.610881] airo(): Found an MPI350 card [ 5.579016] airo(eth1): Firmware version 5.60.21 [ 5.579121] airo(eth1): WPA supported. [ 5.579191] airo(eth1): MAC enabled 00:02:8a:25:27:a8 [ 5.581818] airo(): Finished probing for PCI adapters [ 110.237510] airo(eth1): link lost (local choice) [ 114.256285] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 114.256302] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 114.256357] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 114.257493] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 114.257502] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 114.257727] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 114.258856] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 114.258866] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 114.259957] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 114.261153] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 114.261164] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 114.261226] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 114.262232] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 114.262241] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 120.270865] airo(eth1): cmd:103 status:7f03 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 128.270296] airo(eth1): cmd:103 status:7f03 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 132.806204] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 132.817940] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 132.817959] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 132.861628] airo(eth1): cmd:3 status:7f03 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 132.862728] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 [ 132.863799] airo(eth1): cmd:1 status:7f01 rsp0:88 rsp1:ff10 rsp2:c0f0 [ 132.863809] airo(eth1): Bad MAC enable reason=88, rid=ff10, offset=49392 [ 132.867607] airo(eth1): cmd:2 status:7f02 rsp0:0 rsp1:ff10 rsp2:c0f0 -- Meelis Roos (mroos@xxxxxxxx) -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
