> In AP mode DFS channel state is changed to DFS_AVAILABLE > after successful CAC and remains as such until a radar > signal is detected during the In-Service Monitoring. > When AP is stopped it is no longer monitoring current channel > for radar signals. DFS channel state should be changed > to DFS_USABLE when last AP interface is stopped. Starting AP > again on that channel will start CAC instead of starting radiation. > Sorry for answering after so many revisions, but ... why do you think this is required? Many APs first do a CAC on all available channels, but then pick one channel and use that, while being able to switch to another channel immediately. WIth this patch (if I understand that correctly), this is not possible anymore. Why do you think it is required? I can not find this requirement in ETSI, at least. To quote from ETSI 301.893: Once the RLAN has started operations on an Available Channel, then that channel becomes an Operating Channel. During normal operation, the master device shall monitor all Operating Channels (In-Service Monitoring) to ensure that there is no radar operating within these channel(s). If no radar was detected on an Operating Channel but the RLAN stops operating on that channel, then the channel becomes an Available Channel. I think this patch is wrong and should not be applied. Thanks, Simon -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html