On Wednesday 20 February 2008, Chris Vine wrote:
>
> On Wed, 2008-02-20 at 11:05 -0500, Dan Williams wrote:
> > On Tue, 2008-02-19 at 23:04 +0000, Chris Vine wrote:
> > > On Tue, 2008-02-19 at 20:46 +0100, Ivo van Doorn wrote:
> > > > Hi,
> > > >
> > > > [added rt2400-devel (rt2x00 development mailinglist) to the CC list.]
> > > >
> > > > > > > > I have a series of tests I would like to request from you,
> > > > > > > > you mentioned you already enabled debugfs, and that is just what we need. ;)
> > > > > > > > Please use attached script to create dumps of the hardware register contents.
> > > > > > > >
> > > > > > > > There are specific moments that should be dumped:
> > > > > > > > - kernel 2.6.24 (last known working version for you).
> > > > > > > > - kernel 2.6.25-rc2 (after ifup, before TX dies)
> > > > > > > > - kernel 2.6.25-rc2 (after ifup, after TX dies)
> > > > > > > >
> > > > > > >
> > > > > > > These diagnostics are attached, with obvious filenames.
> > > > > >
> > > > > > Thanks. I think I found something, please test below patch:
> > > > > >
> > > > >
> > > > > I've tried the patch but, unfortunately, my wireless LAN still dies after a few pings.
> > >
> > > rt2x00 2.0.14 is broken with my rt73 stick in the vanilla 2.6.25-rc2
> > > kernel (not wireless-2.6/rt2x00 git). The modules load when I plug the
> > > stick in but I then get a complete kernel lock up with two flashing
> > > leds. Nothing is recorded to system logs. The last logged messages are
> > > that usbcore has registered new interface driver rt73usb, and that the
> > > rate control algorithm has been selected on phy0. This happens whether
> > > the simple or pid mac80211 rate control algorithms have been chosen.
> > >
> > > This is a shame because 2.0.14 was working really well for me until the
> > > mac80211 changes 2 or 3 weeks ago broke it. (Shortly followed by the
> > > release of 2.1.*).
> >
> > Switch to a VT with Ctl+Alt+1, then plug the stick in, and take a
> > picture of the panic if one shows up. _Something_ should show up on the
> > VT.
>
> I did that yesterday and it just reported a kernel panic on the terminal
> with the message:
>
> Kernel panic - not syncing: Aiee, killing interrupt handler!
I have an idea, could you try below patch?
Note that while applying it will mention something about a line offset, but that can be ignored.
This could perhaps also fix the TX/RX issue mentioned earlier in the thread, but I am not
quite sure about that.
---
diff --git a/drivers/net/wireless/rt2x00/rt2400pci.c b/drivers/net/wireless/rt2x00/rt2400pci.c
index b63bc66..460ef2f 100644
--- a/drivers/net/wireless/rt2x00/rt2400pci.c
+++ b/drivers/net/wireless/rt2x00/rt2400pci.c
@@ -953,8 +953,12 @@ static int rt2400pci_set_device_state(struct rt2x00_dev *rt2x00dev,
rt2400pci_disable_radio(rt2x00dev);
break;
case STATE_RADIO_RX_ON:
+ case STATE_RADIO_RX_ON_LINK:
+ rt2400pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ break;
case STATE_RADIO_RX_OFF:
- rt2400pci_toggle_rx(rt2x00dev, state);
+ case STATE_RADIO_RX_OFF_LINK:
+ rt2400pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
break;
case STATE_DEEP_SLEEP:
case STATE_SLEEP:
diff --git a/drivers/net/wireless/rt2x00/rt2500pci.c b/drivers/net/wireless/rt2x00/rt2500pci.c
index add8aff..ffcd996 100644
--- a/drivers/net/wireless/rt2x00/rt2500pci.c
+++ b/drivers/net/wireless/rt2x00/rt2500pci.c
@@ -1106,8 +1106,12 @@ static int rt2500pci_set_device_state(struct rt2x00_dev *rt2x00dev,
rt2500pci_disable_radio(rt2x00dev);
break;
case STATE_RADIO_RX_ON:
+ case STATE_RADIO_RX_ON_LINK:
+ rt2500pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ break;
case STATE_RADIO_RX_OFF:
- rt2500pci_toggle_rx(rt2x00dev, state);
+ case STATE_RADIO_RX_OFF_LINK:
+ rt2500pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
break;
case STATE_DEEP_SLEEP:
case STATE_SLEEP:
diff --git a/drivers/net/wireless/rt2x00/rt2500usb.c b/drivers/net/wireless/rt2x00/rt2500usb.c
index d9643c5..9f59db9 100644
--- a/drivers/net/wireless/rt2x00/rt2500usb.c
+++ b/drivers/net/wireless/rt2x00/rt2500usb.c
@@ -996,8 +996,12 @@ static int rt2500usb_set_device_state(struct rt2x00_dev *rt2x00dev,
rt2500usb_disable_radio(rt2x00dev);
break;
case STATE_RADIO_RX_ON:
+ case STATE_RADIO_RX_ON_LINK:
+ rt2500usb_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ break;
case STATE_RADIO_RX_OFF:
- rt2500usb_toggle_rx(rt2x00dev, state);
+ case STATE_RADIO_RX_OFF_LINK:
+ rt2500usb_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
break;
case STATE_DEEP_SLEEP:
case STATE_SLEEP:
diff --git a/drivers/net/wireless/rt2x00/rt2x00config.c b/drivers/net/wireless/rt2x00/rt2x00config.c
index 46888f9..a1d8e33 100644
--- a/drivers/net/wireless/rt2x00/rt2x00config.c
+++ b/drivers/net/wireless/rt2x00/rt2x00config.c
@@ -127,7 +127,7 @@ void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
* else the changes will be ignored by the device.
*/
if (test_bit(DEVICE_ENABLED_RADIO, &rt2x00dev->flags))
- rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
+ rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF_LINK);
/*
* Write new antenna setup to device and reset the link tuner.
@@ -141,7 +141,7 @@ void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
rt2x00dev->link.ant.active.tx = libconf.ant.tx;
if (test_bit(DEVICE_ENABLED_RADIO, &rt2x00dev->flags))
- rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON_LINK);
}
void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
diff --git a/drivers/net/wireless/rt2x00/rt2x00reg.h b/drivers/net/wireless/rt2x00/rt2x00reg.h
index add1f09..0325bed 100644
--- a/drivers/net/wireless/rt2x00/rt2x00reg.h
+++ b/drivers/net/wireless/rt2x00/rt2x00reg.h
@@ -85,6 +85,8 @@ enum dev_state {
STATE_RADIO_OFF,
STATE_RADIO_RX_ON,
STATE_RADIO_RX_OFF,
+ STATE_RADIO_RX_ON_LINK,
+ STATE_RADIO_RX_OFF_LINK,
STATE_RADIO_IRQ_ON,
STATE_RADIO_IRQ_OFF,
};
diff --git a/drivers/net/wireless/rt2x00/rt61pci.c b/drivers/net/wireless/rt2x00/rt61pci.c
index ca83d94..091fe39 100644
--- a/drivers/net/wireless/rt2x00/rt61pci.c
+++ b/drivers/net/wireless/rt2x00/rt61pci.c
@@ -1458,8 +1458,12 @@ static int rt61pci_set_device_state(struct rt2x00_dev *rt2x00dev,
rt61pci_disable_radio(rt2x00dev);
break;
case STATE_RADIO_RX_ON:
+ case STATE_RADIO_RX_ON_LINK:
+ rt61pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ break;
case STATE_RADIO_RX_OFF:
- rt61pci_toggle_rx(rt2x00dev, state);
+ case STATE_RADIO_RX_OFF_LINK:
+ rt61pci_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
break;
case STATE_DEEP_SLEEP:
case STATE_SLEEP:
diff --git a/drivers/net/wireless/rt2x00/rt73usb.c b/drivers/net/wireless/rt2x00/rt73usb.c
index 7d6ee97..6546b0d 100644
--- a/drivers/net/wireless/rt2x00/rt73usb.c
+++ b/drivers/net/wireless/rt2x00/rt73usb.c
@@ -1196,8 +1196,12 @@ static int rt73usb_set_device_state(struct rt2x00_dev *rt2x00dev,
rt73usb_disable_radio(rt2x00dev);
break;
case STATE_RADIO_RX_ON:
+ case STATE_RADIO_RX_ON_LINK:
+ rt73usb_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON);
+ break;
case STATE_RADIO_RX_OFF:
- rt73usb_toggle_rx(rt2x00dev, state);
+ case STATE_RADIO_RX_OFF_LINK:
+ rt73usb_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF);
break;
case STATE_DEEP_SLEEP:
case STATE_SLEEP:
-
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
