From: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx> This feature isn't supported by the firmware (yet). Note that settingt he values to BT_CFG_CMD is harmless if the validity bit is clear - so keep the configuration values in BT_CFG_CMD, but clear the validity bit until thes feature is enabled in the firmware. Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx> --- drivers/net/wireless/iwlwifi/mvm/bt-coex.c | 1 - 1 file changed, 1 deletion(-) diff --git a/drivers/net/wireless/iwlwifi/mvm/bt-coex.c b/drivers/net/wireless/iwlwifi/mvm/bt-coex.c index 5d066cb..b647147 100644 --- a/drivers/net/wireless/iwlwifi/mvm/bt-coex.c +++ b/drivers/net/wireless/iwlwifi/mvm/bt-coex.c @@ -391,7 +391,6 @@ int iwl_send_bt_init_conf(struct iwl_mvm *mvm) BT_VALID_LUT | BT_VALID_WIFI_RX_SW_PRIO_BOOST | BT_VALID_WIFI_TX_SW_PRIO_BOOST | - BT_VALID_MULTI_PRIO_LUT | BT_VALID_CORUN_LUT_20 | BT_VALID_CORUN_LUT_40 | BT_VALID_ANT_ISOLATION | -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html