My kernel is lightly patched, no patches to ath10k. Looks like something is not checking a NULL pointer, but I did not dig into the code. I'm not actually running any traffic on the ath10k device. ath10k: Completion buffers are full ath10k: Completion buffers are full ath10k: MSI-X interrupt handling (8 intrs) e1000e: eth1 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx ath10k: UART prints disabled ath10k: firmware 1.0.0.636 booted ath10k: htt target version 2.1 ... ath10k: Completion buffers are full ath10k: Completion buffers are full IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready 8021q: adding VLAN 0 to HW filter on device eth1 IPv6: ADDRCONF(NETDEV_UP): sta0: link is not ready IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready IPv6: ADDRCONF(NETDEV_UP): wlan1: link is not ready IPv6: ADDRCONF(NETDEV_UP): sta0: link is not ready IPv6: ADDRCONF(NETDEV_UP): sta0: link is not ready ath10k: MSI-X interrupt handling (8 intrs) ath10k: Unable to wakeup target ath10k: target took longer 5000 us to wake up (awake count 1) ath10k: Failed to get pcie state addr: -16 ath10k: early firmware event indicated BUG: unable to handle kernel NULL pointer dereference at 0000000000000004 IP: [<ffffffffa06ae46c>] ath10k_ce_completed_send_next+0x47/0x122 [ath10k_pci] PGD d1f5b067 PUD d9c1c067 PMD 0 Oops: 0000 [#1] PREEMPT SMP Modules linked in: rpcsec_gss_krb5 auth_rpcgss oid_registry nfsv4 nfs fscache nf_nat_ipv4 nf_nat 8021q ga] CPU: 1 PID: 17 Comm: ksoftirqd/1 Tainted: G C 3.12.0-rc3-wl+ #10 Hardware name: To be filled by O.E.M. To be filled by O.E.M./HURONRIVER, BIOS 4.6.5 05/02/2012 task: ffff8802160fdd80 ti: ffff880216306000 task.ti: ffff880216306000 RIP: 0010:[<ffffffffa06ae46c>] [<ffffffffa06ae46c>] ath10k_ce_completed_send_next+0x47/0x122 [ath10k_pci] RSP: 0018:ffff880216307c98 EFLAGS: 00010246 RAX: 0000000000005b5b RBX: ffff88020bfbfc50 RCX: 0000000000057400 RDX: ffff88020c7e5f20 RSI: ffff880216307d10 RDI: ffff88020bfbfc48 RBP: ffff880216307cf8 R08: ffff880216307d1c R09: ffff8800d967d438 R10: ffff88021fa92ff0 R11: 0000000000000001 R12: ffff880216307d10 R13: ffff880216307d24 R14: ffff880216307d20 R15: 0000000000000000 FS: 0000000000000000(0000) GS:ffff88021fa80000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 0000000000000004 CR3: 00000000d1c76000 CR4: 00000000000407e0 Stack: ffff880216307cc8 ffff8802160fdde8 ffff88021fa92ff0 ffff880216307d1c ffff88020bfbfc48 ffff88021fa92ff0 ffff880216307d08 ffff88020c7e5f20 ffff88020bfbf800 0000000000000000 ffff88020bfbfc48 0000000000057430 Call Trace: [<ffffffffa06ab568>] ath10k_pci_bmi_send_done+0x1d/0x32 [ath10k_pci] [<ffffffff810a4915>] ? local_bh_enable_ip+0x9/0xb [<ffffffff8158e801>] ? _raw_spin_unlock_bh+0x1f/0x21 [<ffffffffa06ae357>] ath10k_ce_per_engine_service+0xab/0xea [ath10k_pci] [<ffffffffa06ab3b4>] ath10k_pci_ce_tasklet+0x15/0x17 [ath10k_pci] [<ffffffff810a3e3e>] tasklet_action+0x78/0xc6 [<ffffffff810a463c>] __do_softirq+0xc4/0x19d [<ffffffff810a4738>] run_ksoftirqd+0x23/0x42 [<ffffffff810c0ea3>] smpboot_thread_fn+0x21e/0x223 [<ffffffff810c0c85>] ? smpboot_create_threads+0x61/0x61 [<ffffffff810ba54d>] kthread+0xb0/0xb8 [<ffffffff810ba49d>] ? kthread_freezable_should_stop+0x5b/0x5b [<ffffffff815939cc>] ret_from_fork+0x7c/0xb0 [<ffffffff810ba49d>] ? kthread_freezable_should_stop+0x5b/0x5b Code: 38 4c 89 45 b8 48 8b 07 48 8b 80 a0 01 00 00 48 05 48 04 00 00 48 89 c7 48 89 45 c0 e8 b6 07 ee e0 RIP [<ffffffffa06ae46c>] ath10k_ce_completed_send_next+0x47/0x122 [ath10k_pci] RSP <ffff880216307c98> CR2: 0000000000000004 ---[ end trace 6b10a0163cca0cc3 ]--- -- Ben Greear <greearb@xxxxxxxxxxxxxxx> Candela Technologies Inc http://www.candelatech.com -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
