On 09/11/2013 12:11 PM, Mark Cave-Ayland wrote:
On 11/09/13 17:33, Larry Finger wrote:
So the AP is disconnecting the device a couple seconds with reason 4,
which is "Disassociated due to inactivity". My thought is that this
points to a driver bug (Larry?).
Possibly, but for reference, my Edimax EW-7811Un has been running for 37
hours. During that time, I have had no deauthentications and only 2
instances of the "AP lost" reconnections. The latter is what I am
currently trying to fix, but at that error rate, it is difficult. I am
running the latest 3.11 kernel from wireless testing.
The only thing I am doing that is unusual is that I am pinging my router
at a 5 second interval using the command
ping -i5 192.168.1.1
It is possible that I am preventing a power save operation, which is
making a difference.
Hi Larry,
For comparison, what does your device report when plugged in? My device reports
this:
Sep 10 00:28:41 kentang kernel: [90532.399226] usb 4-1.2: new high-speed USB
device number 26 using ehci-pci
Sep 10 00:28:41 kentang kernel: [90532.492624] usb 4-1.2: New USB device found,
idVendor=0bda, idProduct=8176
Sep 10 00:28:41 kentang kernel: [90532.492627] usb 4-1.2: New USB device
strings: Mfr=1, Product=2, SerialNumber=3
Sep 10 00:28:41 kentang kernel: [90532.492629] usb 4-1.2: Manufacturer: Realtek
Sep 10 00:28:41 kentang kernel: [90532.492630] usb 4-1.2: SerialNumber:
00e04c000001
Sep 10 00:28:41 kentang kernel: [90532.502454] rtl8192cu: Chip version 0x10
Sep 10 00:28:42 kentang kernel: [90532.581772] rtl8192cu: MAC address:
00:0b:81:89:81:b8
Sep 10 00:28:42 kentang kernel: [90532.581776] rtl8192cu: Board Type 0
Also what type of USB port are you using? I'm plugged direct (no hub) into a
ehci-pci port on a laptop if that makes a difference to power?
My device has USB ID of 7392:7811. The logged data are as follows:
[ 2.844078] usb 1-1: new high-speed USB device number 2 using ehci-pci
[ 3.120082] usb 1-4: new high-speed USB device number 3 using ehci-pci
[ 22.448552] rtl8192cu: Chip version 0x10
[ 22.649915] rtl8192cu: MAC address: 00:1f:1f:c8:8e:cb
[ 22.649926] rtl8192cu: Board Type 0
I am plugged into an ehci port on my laptop; however, the power-saving feature I
discussed refers to the ability of wireless devices to shut down their power
during a period when no packets are expected. The station (STA) informs the
access point (AP) that it is going into that mode, and the AP will not send any
data until the STA is once again ready. Many drivers have the ability to disable
this feature on module loading, but not rtl8192cu (yet). I am looking into
adding this code.
Larry
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
