Hi. What could be going on with WRT160NL access point, stock firmware that my linux (3.10.4) with Intel Corporation Centrino Advanced-N + WiMAX 6250 [Kilmer Peak] (rev 2c) cannot even connect? The same happened with my earlier Intel 5350 wifi card. It basically reports: [79477.496067] eth1: AP 68:7f:74:06:b3:1b changed bandwidth, new config is 2422 MHz, width 1 (2422/0 MHz) [79477.496072] eth1: AP 68:7f:74:06:b3:1b changed bandwidth in a way we can't support - disconnect (note I have two wrt160nl here and problem happens with both) Any hints on why "we can't support" configuration issued by this (common) AP? [79474.704167] eth1: authenticate with 68:7f:74:06:b3:1b [79474.708354] eth1: send auth to 68:7f:74:06:b3:1b (try 1/3) [79474.710051] eth1: authenticated [79474.712304] eth1: associate with 68:7f:74:06:b3:1b (try 1/3) [79474.735808] eth1: RX AssocResp from 68:7f:74:06:b3:1b (capab=0x431 status=0 aid=1) [79474.739952] eth1: associated [79474.834786] eth1: AP 68:7f:74:06:b3:1b changed bandwidth, new config is 2422 MHz, width 1 (2422/0 MHz) [79474.834791] eth1: AP 68:7f:74:06:b3:1b changed bandwidth in a way we can't support - disconnect [79474.877910] cfg80211: Calling CRDA to update world regulatory domain [79474.880204] cfg80211: World regulatory domain updated: [79474.880208] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [79474.880210] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79474.880213] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79474.880215] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [79474.880217] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79474.880219] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79474.880581] cfg80211: Calling CRDA for country: PL [79474.884514] cfg80211: Regulatory domain changed to country: PL [79474.884517] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [79474.884520] cfg80211: (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79474.884522] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79474.884524] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79474.884526] cfg80211: (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm) [79474.884528] cfg80211: (57240000 KHz - 65880000 KHz @ 2160000 KHz), (N/A, 4000 mBm) [79477.468073] eth1: authenticate with 68:7f:74:06:b3:1b [79477.472240] eth1: send auth to 68:7f:74:06:b3:1b (try 1/3) [79477.473923] eth1: authenticated [79477.476176] eth1: associate with 68:7f:74:06:b3:1b (try 1/3) [79477.480118] eth1: RX AssocResp from 68:7f:74:06:b3:1b (capab=0x431 status=0 aid=1) [79477.484355] eth1: associated [79477.496067] eth1: AP 68:7f:74:06:b3:1b changed bandwidth, new config is 2422 MHz, width 1 (2422/0 MHz) [79477.496072] eth1: AP 68:7f:74:06:b3:1b changed bandwidth in a way we can't support - disconnect [79477.506470] eth1: deauthenticating from 68:7f:74:06:b3:1b by local choice (reason=1) [79477.506598] cfg80211: Calling CRDA to update world regulatory domain [79477.512546] cfg80211: World regulatory domain updated: [79477.512550] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [79477.512553] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79477.512556] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79477.512558] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [79477.512560] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79477.512562] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [79477.512884] cfg80211: Calling CRDA for country: PL [79477.516800] cfg80211: Regulatory domain changed to country: PL [79477.516803] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [79477.516806] cfg80211: (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79477.516808] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79477.516810] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm) [79477.516812] cfg80211: (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm) [79477.516814] cfg80211: (57240000 KHz - 65880000 KHz @ 2160000 KHz), (N/A, 4000 mBm) [79480.234322] eth1: authenticate with 68:7f:74:06:b6:75 [79480.234333] eth1: capabilities/regulatory prevented using AP HT/VHT configuration, downgraded [79480.238466] eth1: send auth to 68:7f:74:06:b6:75 (try 1/3) [79480.304305] eth1: send auth to 68:7f:74:06:b6:75 (try 2/3) [79480.325316] eth1: send auth to 68:7f:74:06:b6:75 (try 3/3) [79480.352770] eth1: authentication with 68:7f:74:06:b6:75 timed out [79483.409516] eth1: authenticate with 68:7f:74:06:b6:75 [79483.409527] eth1: capabilities/regulatory prevented using AP HT/VHT configuration, downgraded [79483.411562] eth1: direct probe to 68:7f:74:06:b6:75 (try 1/3) [79483.612029] eth1: direct probe to 68:7f:74:06:b6:75 (try 2/3) [79483.816045] eth1: direct probe to 68:7f:74:06:b6:75 (try 3/3) [79484.020039] eth1: authentication with 68:7f:74:06:b6:75 timed out -- Arkadiusz Miśkiewicz, arekm / maven.pl -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
