sandeep suresh wrote: > I had a look at the source code for Ath9k. For 2-wire coexistence, other than > GPIO configuration (direction, Mux etc) for WLAN_ACTIVE and BT_ACTIVITY, is > there also weight register configuration for BT and WLAN for 2-wire? What > exactly is the meaning of these weight registers? BTCOEX protocol in ath9k can be of 3 types: 2-wire, 3-wire and MCI. All chips in the pre-AR9003 family have separate WLAN and BT devices as part of the same board. In a 2-wire connection between the devices, they are marked as BT_ACTIVE and WLAN_ACTIVE. BT_ACTIVE is driven by the BT device and WLAN_ACTIVE by the WLAN device, obviously. If the Bluetooth device is expecting to TX or RX, it asserts BT_ACTIVE. If WLAN traffic has been prioritized over BT traffic, WLAN_ACTIVE is asserted and Bluetooth traffic is "stomped". Now, the means of "prioritizing" traffic is done based on "weights". For each combination of BT_PRIORITY/BT_[TX|RX], weights are programmed in the HW. The same is done for WLAN. So, when the card is operational and BT_ACTIVE is asserted and if there is current WLAN traffic, the HW checks if the weight of the BT traffic is lower than WLAN and if so, continues to transmit WLAN frames. If BT priority is higher, the HW will *abort* WLAN traffic like there was a collision. I'd assume that at this point, backoff will kick in. 2-wire doesn't have BT_PRIORITY, so traffic classification is very primitive and coexistence is not optimal. 3-wire is much better and the best of the breed is the MCI based scheme implemented in AR9462 and AR9565. These two chips, unlike other WLAN+BT cards like WB195, WB225, WB197 etc. are *combo* chips and hence have a complex system of message-passing to exchange information between the BT-core and WLAN. MCI is built on 3-wire, so it uses the same lines at a basic level. Now, these lines (either 2 or 3) are connected by GPIOs at the WLAN side. They can be programmed as either input or output and the GPIO number is fixed for each card. The WLAN-driven line WLAN_ACTIVE is configured as output and the signals coming in from BT are configured as input. The actual pin numbers can be found in ath9k_hw_btcoex_init_scheme(). This is only the basic picture - there are a lot of other components which interact with each other to provide a more dynamic algorithm to distribute airtime between WLAN and BT. Most of the stuff is in gpio.c and btcoex.c Hope this helps. Sujith -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
