On 02/05/2013 12:00 AM, Thomas Rosenkranz wrote: Larry, are you able to identify the chip of that device with the 8192cu output ? what should he do ? open the device to see the chip ?? > [ 183.369324] rtw driver version=v3.4.4_xxxx.20120730 > [ 183.369330] Build at: Feb 4 2013 23:44:44 > [ 183.369400] usbcore: registered new interface driver rtl8192cu > [ 183.370696] register rtw_netdev_ops to netdev_ops > [ 183.370702] CHIP TYPE: RTL8188C_8192C > [ 183.370706] > [ 183.370707] usb_endpoint_descriptor(0): > [ 183.370710] bLength=7 > [ 183.370711] bDescriptorType=5 > [ 183.370713] bEndpointAddress=81 > [ 183.370715] wMaxPacketSize=200 > [ 183.370717] bInterval=0 > [ 183.370719] RT_usb_endpoint_is_bulk_in = 1 > [ 183.370721] > [ 183.370722] usb_endpoint_descriptor(1): > [ 183.370724] bLength=7 > [ 183.370726] bDescriptorType=5 > [ 183.370727] bEndpointAddress=2 > [ 183.370729] wMaxPacketSize=200 > [ 183.370731] bInterval=0 > [ 183.370733] RT_usb_endpoint_is_bulk_out = 2 > [ 183.370735] > [ 183.370736] usb_endpoint_descriptor(2): > [ 183.370738] bLength=7 > [ 183.370739] bDescriptorType=5 > [ 183.370741] bEndpointAddress=3 > [ 183.370743] wMaxPacketSize=200 > [ 183.370744] bInterval=0 > [ 183.370746] RT_usb_endpoint_is_bulk_out = 3 > [ 183.370748] > [ 183.370749] usb_endpoint_descriptor(3): > [ 183.370751] bLength=7 > [ 183.370752] bDescriptorType=5 > [ 183.370754] bEndpointAddress=84 > [ 183.370756] wMaxPacketSize=40 > [ 183.370758] bInterval=1 > [ 183.370760] RT_usb_endpoint_is_int_in = 4, Interval = 1 > [ 183.370762] nr_endpoint=4, in_num=2, out_num=2 > [ 183.370764] > [ 183.370765] USB_SPEED_HIGH > [ 183.370905] Chip Version ID: VERSION_NORMAL_TSMC_CHIP_88C. > [ 183.370912] RF_Type is 3!! > [ 183.371259] EEPROM type is E-FUSE > [ 183.371263] ====> ReadAdapterInfo8192C > [ 183.371385] Boot from EFUSE, Autoload OK ! > [ 183.556146] EEPROMVID = 0x0bda > [ 183.556150] EEPROMPID = 0x819a > [ 183.556152] EEPROMCustomerID : 0x00 > [ 183.556154] EEPROMSubCustomerID: 0x00 > [ 183.556156] RT_CustomerID: 0x00 > [ 183.556159] _ReadMACAddress MAC Address from EFUSE = 00:1c:7b:a8:a8:f3 > [ 183.556163] EEPROMRegulatory = 0x1 > [ 183.556165] _ReadBoardType(3) > [ 183.556167] BT Coexistance = disable > [ 183.556170] RT_ChannelPlan: 0x0a > [ 183.556172] _ReadPSSetting...bHWPwrPindetect(0)-bHWPowerdown(10) ,bSupportRemoteWakeup(0) > [ 183.556176] ### PS params=> power_mgnt(1),usbss_enable(0) ### > [ 183.556178] ### AntDivCfg(0) > [ 183.556180] readAdapterInfo_8192CU(): REPLACEMENT = 1 > [ 183.556184] <==== ReadAdapterInfo8192C in 184 ms > [ 183.556432] rtw_macaddr_cfg MAC Address = 00:1c:7b:a8:a8:f3 > [ 183.556436] MAC Address from pnetdev->dev_addr= 00:1c:7b:a8:a8:f3 > [ 183.557231] bDriverStopped:1, bSurpriseRemoved:0, bup:0, hw_init_completed:0 > [ 183.571360] bDriverStopped=1 > [ 183.572190] +871x_drv - drv_open, bup=0 > [ 183.576780] ===> FirmwareDownload91C() fw:Rtl819XFwImageArray_TSMC > [ 183.576786] FirmwareDownload92C accquire FW from embedded image > [ 183.576790] fw_ver=v80, fw_subver=0, sig=0x88c0 > [ 183.608627] fw download ok! > [ 183.608631] Set RF Chip ID to RF_6052 and RF type to 1T1R. > [ 183.984930] IQK:Start!!! > [ 183.996309] Path A IQK Success!! > [ 184.004034] Path A IQK Success!! > [ 184.008907] IQK: final_candidate is 0 > [ 184.008911] IQK: RegE94=ff RegE9C=d RegEA4=fd RegEAC=3fd RegEB4=0 RegEBC=0 RegEC4=0 RegECC=0 > [ 184.008914] Path A IQ Calibration Success ! > [ 184.122503] pdmpriv->TxPowerTrackControl = 1 > [ 184.127472] MAC Address from REG_MACID = 00:1c:7b:a8:a8:f3 > [ 184.127476] rtl8192cu_hal_init in 556ms > [ 184.127480] MAC Address = 00:1c:7b:a8:a8:f3 > [ 184.132257] -871x_drv - drv_open, bup=1 > [ 184.133354] ADDRCONF(NETDEV_UP): wlan0: link is not ready > [ 184.133824] ADDRCONF(NETDEV_UP): wlan0: link is not ready > [ 184.133854] set_mode = IW_MODE_INFRA > [ 184.150748] [rtw_wx_set_pmkid] IW_PMKSA_FLUSH! > [ 184.150763] set_mode = IW_MODE_INFRA > [ 184.193691] [rtw_wx_set_pmkid] IW_PMKSA_FLUSH! > [ 185.543612] survey done event(25) > [ 185.593007] IW_SCAN_THIS_ESSID, ssid=nicht dein WLAN, len=15 > [ 186.942758] survey done event(2d) > [ 186.943996] wpa_set_auth_algs, AUTH_ALG_OPEN_SYSTEM > [ 186.944003] set_mode = IW_MODE_INFRA > [ 186.944019] > [ 186.944020] wpa_ie(length:22): > [ 186.944024] 0x30 0x14 0x01 0x00 0x00 0x0f 0xac 0x02 > [ 186.944028] 0x01 0x00 0x00 0x0f 0xac 0x04 0x01 0x00 > [ 186.944031] 0x00 0x0f 0xac 0x02 0x00 0x00 0x00 0x00 > [ 186.944045] =>rtw_wx_set_essid > [ 186.944047] ssid=nicht dein WLAN, len=15 > [ 186.944052] Set SSID under fw_state=0x00000008 > [ 186.944058] [by_bssid:0][assoc_ssid:nicht dein WLAN][to_roaming:0] new candidate: nicht dein WLAN(00:15:0c:f1:0d:d0) rssi:-32 > [ 186.944077] rtw_select_and_join_from_scanned_queue: candidate: nicht dein WLAN(00:15:0c:f1:0d:d0) > [ 186.944090] link to new AP > [ 186.944100] <=rtw_wx_set_essid, ret 0 > [ 186.944110] Set BSSID under fw_state=0x00000088 > [ 187.125476] link to new AP > [ 187.125484] issue_deauth to 00:15:0c:f1:0d:d0 > [ 187.129338] OnAuthClient > [ 187.129349] network.SupportedRates[0]=82 > [ 187.129351] network.SupportedRates[1]=84 > [ 187.129353] network.SupportedRates[2]=8B > [ 187.129356] network.SupportedRates[3]=96 > [ 187.129358] network.SupportedRates[4]=2C > [ 187.129360] network.SupportedRates[5]=0C > [ 187.129362] network.SupportedRates[6]=12 > [ 187.129364] network.SupportedRates[7]=18 > [ 187.129366] network.SupportedRates[8]=24 > [ 187.129368] network.SupportedRates[9]=30 > [ 187.129370] network.SupportedRates[10]=48 > [ 187.129372] network.SupportedRates[11]=60 > [ 187.129374] network.SupportedRates[12]=6C > [ 187.129377] issue_assocreq(): the rate[4]=2C is not supported by STA! > [ 187.129380] bssrate_len = 12 > [ 187.135954] OnAssocRsp > [ 187.135977] report_join_res(1) > [ 187.135983] rtw_joinbss_update_network > [ 187.135994] rtw_joinbss_update_stainfo > [ 187.136060] HW_VAR_BASIC_RATE: BrateCfg(0x15d) > [ 187.137196] HTOnAssocRsp > [ 187.137334] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready > [ 187.142408] update raid entry, mask=0x40000fff, arg=0x80 > [ 187.143905] rtl8192c_set_FwJoinBssReport_cmd mstatus(1) > [ 187.144776] SetFwRsvdPagePkt > [ 187.144787] Set RSVD page location to Fw. > [ 187.145453] > [ 187.145455] ~~~~stastakey:unicastkey > [ 187.145524] > [ 187.145525] ~~~~stastakey:groupkey > [ 187.145529] ==> rtw_set_key algorithm(2),keyid(2),key_mask(4) > [ 187.145903] =>mlmeext_joinbss_event_callback > [ 187.811595] rx bc/mc packets, to perform sw rtw_tkip_decrypt > [ 188.141761] rtl8192c_dm_RF_Saving(): RF_Save > [ 197.538636] wlan0: no IPv6 routers present > tommy@Tommy-AIO:~$ lsusb -v -d 0bda:819a > > Bus 001 Device 006: ID 0bda:819a Realtek Semiconductor Corp. > Couldn't open device, some information will be missing > Device Descriptor: > bLength 18 > bDescriptorType 1 > bcdUSB 2.00 > bDeviceClass 0 (Defined at Interface level) > bDeviceSubClass 0 > bDeviceProtocol 0 > bMaxPacketSize0 64 > idVendor 0x0bda Realtek Semiconductor Corp. > idProduct 0x819a > bcdDevice 2.00 > iManufacturer 1 > iProduct 2 > iSerial 3 > bNumConfigurations 1 > Configuration Descriptor: > bLength 9 > bDescriptorType 2 > wTotalLength 46 > bNumInterfaces 1 > bConfigurationValue 1 > iConfiguration 0 > bmAttributes 0xa0 > (Bus Powered) > Remote Wakeup > MaxPower 500mA > Interface Descriptor: > bLength 9 > bDescriptorType 4 > bInterfaceNumber 0 > bAlternateSetting 0 > bNumEndpoints 4 > bInterfaceClass 255 Vendor Specific Class > bInterfaceSubClass 255 Vendor Specific Subclass > bInterfaceProtocol 255 Vendor Specific Protocol > iInterface 0 > Endpoint Descriptor: > bLength 7 > bDescriptorType 5 > bEndpointAddress 0x81 EP 1 IN > bmAttributes 2 > Transfer Type Bulk > Synch Type None > Usage Type Data > wMaxPacketSize 0x0200 1x 512 bytes > bInterval 0 > Endpoint Descriptor: > bLength 7 > bDescriptorType 5 > bEndpointAddress 0x02 EP 2 OUT > bmAttributes 2 > Transfer Type Bulk > Synch Type None > Usage Type Data > wMaxPacketSize 0x0200 1x 512 bytes > bInterval 0 > Endpoint Descriptor: > bLength 7 > bDescriptorType 5 > bEndpointAddress 0x03 EP 3 OUT > bmAttributes 2 > Transfer Type Bulk > Synch Type None > Usage Type Data > wMaxPacketSize 0x0200 1x 512 bytes > bInterval 0 > Endpoint Descriptor: > bLength 7 > bDescriptorType 5 > bEndpointAddress 0x84 EP 4 IN > bmAttributes 3 > Transfer Type Interrupt > Synch Type None > Usage Type Data > wMaxPacketSize 0x0040 1x 64 bytes > bInterval 1 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
