This adds a driver for the Broadcom USB OHCI HCD device.
These devices are found in various embedded Broadcom-47xx machines.
Signed-off-by: Michael Buesch <mb@xxxxxxxxx>
Index: linux-2.6/drivers/usb/host/ohci-ssb.c
===================================================================
--- /dev/null 1970-01-01 00:00:00.000000000 +0000
+++ linux-2.6/drivers/usb/host/ohci-ssb.c 2007-07-12 10:52:45.000000000 +0200
@@ -0,0 +1,254 @@
+/*
+ * Sonics Silicon Backplane
+ * Broadcom USB-core OHCI driver
+ *
+ * Copyright 2007 Michael Buesch <mb@xxxxxxxxx>
+ *
+ * Derived from the OHCI-PCI driver
+ * Copyright 1999 Roman Weissgaerber
+ * Copyright 2000-2002 David Brownell
+ * Copyright 1999 Linus Torvalds
+ * Copyright 1999 Gregory P. Smith
+ *
+ * Derived from the USBcore related parts of Broadcom-SB
+ * Copyright 2005 Broadcom Corporation
+ *
+ * Licensed under the GNU/GPL. See COPYING for details.
+ */
+
+#include <linux/ssb/ssb.h>
+
+
+#define SSB_OHCI_TMSLOW_HOSTMODE (1 << 29)
+
+struct ssb_ohci_device {
+ struct ohci_hcd ohci; /* _must_ be at the beginning. */
+
+ u32 enable_flags;
+};
+
+
+static inline
+struct ssb_ohci_device * hcd_to_ssb_ohci(struct usb_hcd *hcd)
+{
+ return (struct ssb_ohci_device *)(hcd->hcd_priv);
+}
+
+
+static const struct ssb_device_id ssb_ohci_table[] = {
+ SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_USB11_HOSTDEV, SSB_ANY_REV),
+ SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_USB11_HOST, SSB_ANY_REV),
+ SSB_DEVTABLE_END
+};
+MODULE_DEVICE_TABLE(ssb, ssb_ohci_table);
+
+
+static int ssb_ohci_reset(struct usb_hcd *hcd)
+{
+ struct ssb_ohci_device *ohcidev = hcd_to_ssb_ohci(hcd);
+ struct ohci_hcd *ohci = &ohcidev->ohci;
+ int err;
+
+ ohci_hcd_init(ohci);
+ err = ohci_init(ohci);
+
+ return err;
+}
+
+static int ssb_ohci_start(struct usb_hcd *hcd)
+{
+ struct ssb_ohci_device *ohcidev = hcd_to_ssb_ohci(hcd);
+ struct ohci_hcd *ohci = &ohcidev->ohci;
+ int err;
+
+ err = ohci_run(ohci);
+ if (err < 0) {
+ ohci_err(ohci, "can't start\n");
+ ohci_stop(hcd);
+ }
+
+ return err;
+}
+
+#ifdef CONFIG_PM
+static int ssb_ohci_hcd_suspend(struct usb_hcd *hcd, pm_message_t message)
+{
+ struct ssb_ohci_device *ohcidev = hcd_to_ssb_ohci(hcd);
+ struct ohci_hcd *ohci = &ohcidev->ohci;
+ unsigned long flags;
+
+ spin_lock_irqsave(&ohci->lock, flags);
+
+ ohci_writel(ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
+ ohci_readl(ohci, &ohci->regs->intrdisable); /* commit write */
+
+ /* make sure snapshot being resumed re-enumerates everything */
+ if (message.event == PM_EVENT_PRETHAW)
+ ohci_usb_reset(ohci);
+
+ clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
+
+ spin_unlock_irqrestore(&ohci->lock, flags);
+
+ return 0;
+}
+
+static int ssb_ohci_hcd_resume(struct usb_hcd *hcd)
+{
+ set_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
+ usb_hcd_resume_root_hub(hcd);
+ return 0;
+}
+#endif /* CONFIG_PM */
+
+static const struct hc_driver ssb_ohci_hc_driver = {
+ .description = "ssb-usb-ohci",
+ .product_desc = "SSB OHCI Controller",
+ .hcd_priv_size = sizeof(struct ssb_ohci_device),
+
+ .irq = ohci_irq,
+ .flags = HCD_MEMORY | HCD_USB11,
+
+ .reset = ssb_ohci_reset,
+ .start = ssb_ohci_start,
+ .stop = ohci_stop,
+ .shutdown = ohci_shutdown,
+
+#ifdef CONFIG_PM
+ .suspend = ssb_ohci_hcd_suspend,
+ .resume = ssb_ohci_hcd_resume,
+#endif
+
+ .urb_enqueue = ohci_urb_enqueue,
+ .urb_dequeue = ohci_urb_dequeue,
+ .endpoint_disable = ohci_endpoint_disable,
+
+ .get_frame_number = ohci_get_frame,
+
+ .hub_status_data = ohci_hub_status_data,
+ .hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
+
+#ifdef CONFIG_PM
+ .bus_suspend = ohci_bus_suspend,
+ .bus_resume = ohci_bus_resume,
+#endif
+
+ .start_port_reset = ohci_start_port_reset,
+};
+
+
+static void ssb_ohci_detach(struct ssb_device *dev)
+{
+ struct usb_hcd *hcd = ssb_get_drvdata(dev);
+
+ usb_remove_hcd(hcd);
+ iounmap(hcd->regs);
+ usb_put_hcd(hcd);
+ ssb_device_disable(dev, 0);
+}
+
+static int ssb_ohci_attach(struct ssb_device *dev)
+{
+ struct ssb_ohci_device *ohcidev;
+ struct usb_hcd *hcd;
+ int err = -ENOMEM;
+ u32 tmp, flags = 0;
+
+ if (dev->id.coreid == SSB_DEV_USB11_HOSTDEV)
+ flags |= SSB_OHCI_TMSLOW_HOSTMODE;
+
+ ssb_device_enable(dev, flags);
+
+ hcd = usb_create_hcd(&ssb_ohci_hc_driver, dev->dev,
+ dev->dev->bus_id);
+ if (!hcd)
+ goto err_dev_disable;
+ ohcidev = hcd_to_ssb_ohci(hcd);
+ ohcidev->enable_flags = flags;
+
+ tmp = ssb_read32(dev, SSB_ADMATCH0);
+ hcd->rsrc_start = ssb_admatch_base(tmp);
+ hcd->rsrc_len = ssb_admatch_size(tmp);
+ hcd->regs = ioremap_nocache(hcd->rsrc_start, hcd->rsrc_len);
+ if (!hcd->regs)
+ goto err_put_hcd;
+ err = usb_add_hcd(hcd, dev->irq, IRQF_SHARED);
+ if (err)
+ goto err_iounmap;
+
+ ssb_set_drvdata(dev, hcd);
+
+ return err;
+
+err_iounmap:
+ iounmap(hcd->regs);
+err_put_hcd:
+ usb_put_hcd(hcd);
+err_dev_disable:
+ ssb_device_disable(dev, flags);
+ return err;
+}
+
+static int ssb_ohci_probe(struct ssb_device *dev,
+ const struct ssb_device_id *id)
+{
+ int err;
+ u16 chipid_top;
+
+ chipid_top = (dev->bus->chip_id & 0xFF00);
+ if (chipid_top != 0x4700 &&
+ chipid_top != 0x5300) {
+ /* USBcores are only connected on embedded devices. */
+ return -ENODEV;
+ }
+ /* TODO: Probably need more checks here whether the core is connected. */
+
+ if (usb_disabled())
+ return -ENODEV;
+
+ /* We currently always attach SSB_DEV_USB11_HOSTDEV
+ * as HOST OHCI. If we want to attach it as Client device,
+ * we must branch here and call into the (yet to
+ * be written) Client mode driver. Same for remove(). */
+
+ err = ssb_ohci_attach(dev);
+
+ return err;
+}
+
+static void ssb_ohci_remove(struct ssb_device *dev)
+{
+ ssb_ohci_detach(dev);
+}
+
+#ifdef CONFIG_PM
+static int ssb_ohci_suspend(struct ssb_device *dev, pm_message_t state)
+{
+ ssb_device_disable(dev, 0);
+
+ return 0;
+}
+
+static int ssb_ohci_resume(struct ssb_device *dev)
+{
+ struct usb_hcd *hcd = ssb_get_drvdata(dev);
+ struct ssb_ohci_device *ohcidev = hcd_to_ssb_ohci(hcd);
+
+ ssb_device_enable(dev, ohcidev->enable_flags);
+
+ return 0;
+}
+#else /* CONFIG_PM */
+# define ssb_ohci_suspend NULL
+# define ssb_ohci_resume NULL
+#endif /* CONFIG_PM */
+
+static struct ssb_driver ssb_ohci_driver = {
+ .name = KBUILD_MODNAME,
+ .id_table = ssb_ohci_table,
+ .probe = ssb_ohci_probe,
+ .remove = ssb_ohci_remove,
+ .suspend = ssb_ohci_suspend,
+ .resume = ssb_ohci_resume,
+};
Index: linux-2.6/drivers/usb/host/ohci-hcd.c
===================================================================
--- linux-2.6.orig/drivers/usb/host/ohci-hcd.c 2007-07-12 10:51:46.000000000 +0200
+++ linux-2.6/drivers/usb/host/ohci-hcd.c 2007-07-12 10:52:45.000000000 +0200
@@ -920,11 +920,17 @@ MODULE_LICENSE ("GPL");
#define PS3_SYSTEM_BUS_DRIVER ps3_ohci_sb_driver
#endif
+#ifdef CONFIG_USB_OHCI_HCD_SSB
+#include "ohci-ssb.c"
+#define SSB_OHCI_DRIVER ssb_ohci_driver
+#endif
+
#if !defined(PCI_DRIVER) && \
!defined(PLATFORM_DRIVER) && \
!defined(OF_PLATFORM_DRIVER) && \
!defined(SA1111_DRIVER) && \
- !defined(PS3_SYSTEM_BUS_DRIVER)
+ !defined(PS3_SYSTEM_BUS_DRIVER) && \
+ !defined(SSB_OHCI_DRIVER)
#error "missing bus glue for ohci-hcd"
#endif
@@ -972,10 +978,20 @@ static int __init ohci_hcd_mod_init(void
goto error_pci;
#endif
+#ifdef SSB_OHCI_DRIVER
+ retval = ssb_driver_register(&SSB_OHCI_DRIVER);
+ if (retval)
+ goto error_ssb;
+#endif
+
return retval;
/* Error path */
+#ifdef SSB_OHCI_DRIVER
+ error_ssb:
+#endif
#ifdef PCI_DRIVER
+ pci_unregister_driver(&PCI_DRIVER);
error_pci:
#endif
#ifdef SA1111_DRIVER
@@ -1001,6 +1017,9 @@ module_init(ohci_hcd_mod_init);
static void __exit ohci_hcd_mod_exit(void)
{
+#ifdef SSB_OHCI_DRIVER
+ ssb_driver_unregister(&SSB_OHCI_DRIVER);
+#endif
#ifdef PCI_DRIVER
pci_unregister_driver(&PCI_DRIVER);
#endif
Index: linux-2.6/drivers/usb/host/Kconfig
===================================================================
--- linux-2.6.orig/drivers/usb/host/Kconfig 2007-07-12 10:51:46.000000000 +0200
+++ linux-2.6/drivers/usb/host/Kconfig 2007-07-12 10:52:45.000000000 +0200
@@ -142,6 +142,19 @@ config USB_OHCI_HCD_PCI
Enables support for PCI-bus plug-in USB controller cards.
If unsure, say Y.
+config USB_OHCI_HCD_SSB
+ bool "OHCI support for the Broadcom SSB OHCI core (embedded systems only)"
+ depends on USB_OHCI_HCD && ((USB_OHCI_HCD=m && SSB) || (USB_OHCI_HCD=y && SSB=y)) && EXPERIMENTAL
+ default n
+ ---help---
+ Support for the Sonics Silicon Backplane (SSB) attached
+ Broadcom USB OHCI core.
+
+ This device is only present in some embedded devices with
+ Broadcom based SSB bus.
+
+ If unsure, say N.
+
config USB_OHCI_BIG_ENDIAN_DESC
bool
depends on USB_OHCI_HCD
--
Greetings Michael.
-
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
