On Friday 04 May 2007 14:37:05 you wrote: > (CCing linux-wireless, other people might have ideas) > > Matteo Croce skrev: > > Every day i gets offline after reading this in the syslog: > > > > May 3 15:25:30 raver kernel: airo(): Probing for PCI adapters > > May 3 15:25:30 raver kernel: airo(eth0): cmd:111 status:7f11 rsp0:2 > > rsp1:0 rsp2:0 May 3 15:25:30 raver kernel: airo(eth0): Doing fast > > bap_reads > > May 3 15:25:30 raver kernel: airo(eth0): WPA is supported. > > May 3 15:25:30 raver kernel: airo(eth0): MAC enabled 0:d:29:4f:c:be > > May 3 15:25:30 raver kernel: airo(): Finished probing for PCI adapters > > May 3 17:59:36 raver kernel: airo(eth0): Bad size 8192 > > May 3 18:47:52 raver kernel: airo(eth0): Bad size 8192 > > May 3 19:05:47 raver kernel: airo(eth0): Bad size 8192 > > May 3 19:08:08 raver kernel: airo(eth0): Bad size 8192 > > May 3 19:20:07 raver kernel: airo(eth0): airo: BAP setup error too many > > retries May 3 19:20:07 raver kernel: airo(eth0): airo: BAP setup error > > too many retries May 3 19:20:09 raver kernel: airo(eth0): airo: BAP > > setup error too many retries May 3 19:20:09 raver kernel: airo(eth0): > > airo: BAP setup error too many retries May 3 19:20:09 raver kernel: > > airo(eth0): airo: BAP setup error too many retries May 3 19:20:09 raver > > kernel: airo(eth0): airo: BAP setup error too many retries May 3 > > 19:20:09 raver kernel: airo(eth0): airo: BAP setup error too many retries > > May 3 19:20:09 raver kernel: airo(eth0): airo: BAP setup error too many > > retries May 3 19:20:09 raver kernel: airo(eth0): airo: BAP setup error > > too many retries May 3 19:20:09 raver kernel: airo(eth0): airo: BAP > > setup error too many retries May 3 19:20:09 raver kernel: airo(eth0): > > airo: BAP setup error too many retries May 3 19:20:10 raver kernel: > > airo(eth0): airo: BAP setup error too many retries May 3 19:20:10 raver > > kernel: airo(eth0): airo: BAP setup error too many retries > > Hi, > > What kernel version are you using? Is this a regression? If so, what was > the last version that worked well? I'm using 2.6.21, last version that worked well is something like 2.6.15 > What if you rmmod the driver and then reload it? Does it make it work > again? Yes, it does work again > What hardware is it exactly? The airo driver supports more than one > type of card. Cisco Aironet 350 PCI $ cat /proc/driver/aironet/eth0/Status Status: CFG ACT SYN LNK PRIV KEY WEP Mode: 3bf Signal Strength: 70 Signal Quality: 34 SSID: cocorico AP: Freq: 0 BitRate: 11mbs Driver Version: airo.c 0.6 (Ben Reed & Javier Achirica) Device: 350 Series Manufacturer: Cisco Systems Firmware Version: 5.60.21 Radio type: 2 Country: 1 Hardware Version: 22 Software Version: 560 Software Subversion: 15 Boot block version: 150 > Are you doing anything special with the card, like running some wifi > monitoring application for instance? No, just web and mail > Michal - To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
