From: Joerg Sommer <joerg@xxxxxxxxxxxx> The frequency to channel routine in bcm43xx requires that the frequency be in MHz, but that condition is not always met. This patch does the necessary conversion. Signed-off-by: Joerg Sommer <joerg@xxxxxxxxxxxx> Signed-off-by: Larry Finger <Larry.Finger@xxxxxxxxxxxx> --- Index: wireless-2.6/drivers/net/wireless/bcm43xx/bcm43xx_wx.c =================================================================== --- wireless-2.6.orig/drivers/net/wireless/bcm43xx/bcm43xx_wx.c +++ wireless-2.6/drivers/net/wireless/bcm43xx/bcm43xx_wx.c @@ -106,18 +106,24 @@ static int bcm43xx_wx_set_channelfreq(st struct bcm43xx_private *bcm = bcm43xx_priv(net_dev); unsigned long flags; u8 channel; + s8 expon; int freq; int err = -EINVAL; mutex_lock(&bcm->mutex); spin_lock_irqsave(&bcm->irq_lock, flags); - if ((data->freq.m >= 0) && (data->freq.m <= 1000)) { + if ((data->freq.e == 0) && + (data->freq.m >= 0) && (data->freq.m <= 1000)) { channel = data->freq.m; freq = bcm43xx_channel_to_freq(bcm, channel); } else { - channel = bcm43xx_freq_to_channel(bcm, data->freq.m); freq = data->freq.m; + expon = 6 - data->freq.e; + while (--expon >= 0) /* scale down the frequency to MHz */ + freq /= 10; + assert(freq > 1000); + channel = bcm43xx_freq_to_channel(bcm, freq); } if (!ieee80211_is_valid_channel(bcm->ieee, channel)) goto out_unlock; --- - To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html