Hi, ? So as I last mentioned I am able to see the "wmx0" interface when I type ifconfig. Now I have run into a new issue.? I installed the Intel Binary Supplicant and Network Service.? However when I enter "/etc/init.d/wimax start" the service starts up then stops running after a few seconds.? Without this daemon running I cannot issue any wimaxcu commands. ? Any ideas? ? Thanks, Brandon --- On Wed, 11/18/09, Brandon Dell <stymiecc04 at yahoo.com> wrote: From: Brandon Dell <stymiecc04 at yahoo.com> Subject: Re: Intel 5350 Firmware Download Issue To: "Jerone Young" <jerone.young at canonical.com>, "Inaky Perez-Gonzalez" <inaky at linux.intel.com> Cc: wimax at linuxwimax.org Date: Wednesday, November 18, 2009, 7:14 AM Hi all, ? Yesterday I rebuilt my kernel using 2.6.29 from kernel.org and the card is being recognized now.? I am going to investigate what differences, if any, there are between 2.6.29 and 2.6.31. ? Thanks for all you guys' help, Brandon --- On Tue, 11/17/09, Inaky Perez-Gonzalez <inaky at linux.intel.com> wrote: From: Inaky Perez-Gonzalez <inaky at linux.intel.com> Subject: Re: Intel 5350 Firmware Download Issue To: "Jerone Young" <jerone.young at canonical.com> Cc: "Brandon Dell" <stymiecc04 at yahoo.com>, wimax at linuxwimax.org Date: Tuesday, November 17, 2009, 5:48 PM On Tue, 2009-11-17 at 14:56 -0600, Jerone Young wrote: > Are you testing with kernels 2.6.31 & greater? Apparently according to > Kevin it works with 2.6.30 & below. Yeap, I do. my tree is in 2.6.32-rc3 -----Inline Attachment Follows----- _______________________________________________ wimax mailing list wimax at linuxwimax.org http://lists.linuxwimax.org/listinfo/wimax -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.linuxwimax.org/pipermail/wimax/attachments/20091118/d420581b/attachment.html>
