[PATCH 14/40] wimax: Makefile, Kconfig and docbook linkage for the stack

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



This patch provides Makefile and KConfig for the WiMAX stack,
integrating them into the networking stack's Makefile, Kconfig and
doc-book templates.

Signed-off-by: Inaky Perez-Gonzalez <inaky@xxxxxxxxxxxxxxx>
---
 Documentation/DocBook/networking.tmpl |    8 +++++++
 net/Kconfig                           |    2 +
 net/Makefile                          |    1 +
 net/wimax/Kconfig                     |   36 +++++++++++++++++++++++++++++++++
 net/wimax/Makefile                    |   13 +++++++++++
 5 files changed, 60 insertions(+), 0 deletions(-)
 create mode 100644 net/wimax/Kconfig
 create mode 100644 net/wimax/Makefile

diff --git a/Documentation/DocBook/networking.tmpl b/Documentation/DocBook/networking.tmpl
index f24f9e8..7053c1c 100644
--- a/Documentation/DocBook/networking.tmpl
+++ b/Documentation/DocBook/networking.tmpl
@@ -101,6 +101,14 @@ X!Enet/core/wireless.c
      <sect1><title>Synchronous PPP</title>
 !Edrivers/net/wan/syncppp.c
      </sect1>
+     <sect1><title>WiMAX</title>
+!Enet/wimax/op-msg.c
+!Enet/wimax/op-reset.c
+!Enet/wimax/op-rfkill.c
+!Enet/wimax/stack.c
+!Iinclude/net/wimax.h
+!Iinclude/linux/wimax.h
+     </sect1>
   </chapter>
 
 </book>
diff --git a/net/Kconfig b/net/Kconfig
index d789d79..3bff221 100644
--- a/net/Kconfig
+++ b/net/Kconfig
@@ -251,6 +251,8 @@ source "net/ieee80211/Kconfig"
 
 endif # WIRELESS
 
+source "net/wimax/Kconfig"
+
 source "net/rfkill/Kconfig"
 source "net/9p/Kconfig"
 
diff --git a/net/Makefile b/net/Makefile
index 27d1f10..620a505 100644
--- a/net/Makefile
+++ b/net/Makefile
@@ -61,3 +61,4 @@ obj-$(CONFIG_NET_9P)		+= 9p/
 ifeq ($(CONFIG_NET),y)
 obj-$(CONFIG_SYSCTL)		+= sysctl_net.o
 endif
+obj-$(CONFIG_WIMAX)		+= wimax/
diff --git a/net/wimax/Kconfig b/net/wimax/Kconfig
new file mode 100644
index 0000000..67d5f4d
--- /dev/null
+++ b/net/wimax/Kconfig
@@ -0,0 +1,36 @@
+#
+# WiMAX LAN device configuration
+#
+
+menuconfig WIMAX
+       tristate "WiMAX Wireless Broadband support"
+       help
+
+         Select to configure support for devices that provide wireless
+         broadband connectivity using the WiMAX protocol (IEEE 802.16).
+
+         Please note that most of these devices require signing up for
+         a service plan with a provider.
+
+         The different WiMAX drivers can be enabled in the menu entry
+
+         Device Drivers > Network device support > WiMAX Wireless Broadband devices
+
+         If unsure, it is safe to select M (module).
+
+config WIMAX_DEBUG_LEVEL
+       int "WiMAX debug level"
+       depends on WIMAX
+       default 8
+       help
+
+         Select the maximum debug verbosity level to be compiled into
+         the WiMAX stack code.
+
+         By default, debug messages are disabled at runtime and can be
+         selectively enabled for different parts of the code using the
+         sysfs debug-levels file.
+
+         If set at zero, this will compile out all the debug code.
+
+         It is recommended that it is left at 8.
diff --git a/net/wimax/Makefile b/net/wimax/Makefile
new file mode 100644
index 0000000..d548446
--- /dev/null
+++ b/net/wimax/Makefile
@@ -0,0 +1,13 @@
+
+obj-$(CONFIG_WIMAX)		+= wimax.o
+
+wimax-objs :=		\
+	id-table.o	\
+	op-msg.o	\
+	op-reset.o	\
+	op-rfkill.o	\
+	stack.o
+
+wimax-$(CONFIG_DEBUG_FS) += debugfs.o
+
+
-- 
1.5.6.5


[Index of Archives]     [Linux Kernel]     [Linux Wireless]     [Linux Bluetooth]     [Linux Netdev]     [Linux Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]

  Powered by Linux