After adding the IRQ request, the BRIDGE_CAUSE bit should be cleared by the bridge interrupt controller. There's no longer a need to do it in the watchdog driver, so we can simply remove it. Reviewed-by: Guenter Roeck <linux@xxxxxxxxxxxx> Tested-by: Sebastian Hesselbarth <sebastian.hesselbarth@xxxxxxxxx> Signed-off-by: Ezequiel Garcia <ezequiel.garcia@xxxxxxxxxxxxxxxxxx> --- drivers/watchdog/orion_wdt.c | 5 ----- 1 file changed, 5 deletions(-) diff --git a/drivers/watchdog/orion_wdt.c b/drivers/watchdog/orion_wdt.c index fce0ec8..adacfd5 100644 --- a/drivers/watchdog/orion_wdt.c +++ b/drivers/watchdog/orion_wdt.c @@ -24,7 +24,6 @@ #include <linux/clk.h> #include <linux/err.h> #include <linux/of.h> -#include <mach/bridge-regs.h> /* RSTOUT mask register physical address for Orion5x, Kirkwood and Dove */ #define ORION_RSTOUT_MASK_OFFSET 0x20108 @@ -42,7 +41,6 @@ #define WDT_MAX_CYCLE_COUNT 0xffffffff #define WDT_RESET_OUT_EN BIT(1) -#define WDT_INT_REQ BIT(3) static bool nowayout = WATCHDOG_NOWAYOUT; static int heartbeat = -1; /* module parameter (seconds) */ @@ -64,9 +62,6 @@ static int orion_wdt_start(struct watchdog_device *wdt_dev) /* Set watchdog duration */ writel(wdt_tclk * wdt_dev->timeout, wdt_reg + WDT_VAL); - /* Clear watchdog timer interrupt */ - writel(~WDT_INT_REQ, BRIDGE_CAUSE); - /* Enable watchdog timer */ atomic_io_modify(wdt_reg + TIMER_CTRL, WDT_EN, WDT_EN); -- 1.8.1.5 -- To unsubscribe from this list: send the line "unsubscribe linux-watchdog" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html