> From: Jiri Pirko <jiri@xxxxxxxxxxx> > Sent: Monday, June 17, 2024 5:10 PM > > Mon, Jun 17, 2024 at 11:44:53AM CEST, parav@xxxxxxxxxx wrote: > > > >> From: Jiri Pirko <jiri@xxxxxxxxxxx> > >> Sent: Monday, June 17, 2024 3:09 PM > >> > >> Mon, Jun 17, 2024 at 04:57:23AM CEST, parav@xxxxxxxxxx wrote: > >> > > >> > > >> >> From: Jason Wang <jasowang@xxxxxxxxxx> > >> >> Sent: Monday, June 17, 2024 7:18 AM > >> >> > >> >> On Wed, Jun 12, 2024 at 2:30 PM Jiri Pirko <jiri@xxxxxxxxxxx> wrote: > >> >> > > >> >> > Wed, Jun 12, 2024 at 03:58:10AM CEST, kuba@xxxxxxxxxx wrote: > >> >> > >On Tue, 11 Jun 2024 13:32:32 +0800 Cindy Lu wrote: > >> >> > >> Add new UAPI to support the mac address from vdpa tool > >> >> > >> Function > >> >> > >> vdpa_nl_cmd_dev_config_set_doit() will get the MAC address > >> >> > >> from the vdpa tool and then set it to the device. > >> >> > >> > >> >> > >> The usage is: vdpa dev set name vdpa_name mac > >> >> > >> **:**:**:**:**:** > >> >> > > > >> >> > >Why don't you use devlink? > >> >> > > >> >> > Fair question. Why does vdpa-specific uapi even exist? To have > >> >> > driver-specific uapi Does not make any sense to me :/ > >> >> > >> >> It came with devlink first actually, but switched to a dedicated uAPI. > >> >> > >> >> Parav(cced) may explain more here. > >> >> > >> >Devlink configures function level mac that applies to all protocol > >> >devices > >> (vdpa, rdma, netdev) etc. > >> >Additionally, vdpa device level mac can be different (an additional > >> >one) to > >> apply to only vdpa traffic. > >> >Hence dedicated uAPI was added. > >> > >> There is 1:1 relation between vdpa instance and devlink port, isn't it? > >> Then we have: > >> devlink port function set DEV/PORT_INDEX hw_addr ADDR > >> > >Above command is privilege command done by the hypervisor on the port > function. > >Vpda level setting the mac is similar to a function owner driver setting the > mac on the self netdev (even though devlink side has configured some mac for > it). > >For example, > >$ ip link set dev wlan1 address 00:11:22:33:44:55 > > Hmm, under what sceratio exacly this is needed? The administrator on the host creating a vdpa device for the VM wants to configure the mac address for the VM. This administrator may not have the access to the devlink port function. Or he may just prefer a different MAC (theoretical case). > I mean, the VM that has VDPA device can actually do that too. VM cannot do. Virtio spec do not allow modifying the mac address. > That is the actual function owner. vdpa is not mapping a whole VF to the VM. It is getting some synthetic PCI device composed using several software (kernel) and user space layers. so VM is not the function owner.
