Re: [PATCH v2 1/8] riscv: mm: Pre-allocate vmemmap/direct map PGD entries

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Björn,

On Tue, May 14, 2024 at 4:05 PM Björn Töpel <bjorn@xxxxxxxxxx> wrote:
>
> From: Björn Töpel <bjorn@xxxxxxxxxxxx>
>
> The RISC-V port copies the PGD table from init_mm/swapper_pg_dir to
> all userland page tables, which means that if the PGD level table is
> changed, other page tables has to be updated as well.
>
> Instead of having the PGD changes ripple out to all tables, the
> synchronization can be avoided by pre-allocating the PGD entries/pages
> at boot, avoiding the synchronization all together.
>
> This is currently done for the bpf/modules, and vmalloc PGD regions.
> Extend this scheme for the PGD regions touched by memory hotplugging.
>
> Prepare the RISC-V port for memory hotplug by pre-allocate
> vmemmap/direct map entries at the PGD level. This will roughly waste
> ~128 worth of 4K pages when memory hotplugging is enabled in the
> kernel configuration.
>
> Signed-off-by: Björn Töpel <bjorn@xxxxxxxxxxxx>
> ---
>  arch/riscv/include/asm/kasan.h | 4 ++--
>  arch/riscv/mm/init.c           | 7 +++++++
>  2 files changed, 9 insertions(+), 2 deletions(-)
>
> diff --git a/arch/riscv/include/asm/kasan.h b/arch/riscv/include/asm/kasan.h
> index 0b85e363e778..e6a0071bdb56 100644
> --- a/arch/riscv/include/asm/kasan.h
> +++ b/arch/riscv/include/asm/kasan.h
> @@ -6,8 +6,6 @@
>
>  #ifndef __ASSEMBLY__
>
> -#ifdef CONFIG_KASAN
> -
>  /*
>   * The following comment was copied from arm64:
>   * KASAN_SHADOW_START: beginning of the kernel virtual addresses.
> @@ -34,6 +32,8 @@
>   */
>  #define KASAN_SHADOW_START     ((KASAN_SHADOW_END - KASAN_SHADOW_SIZE) & PGDIR_MASK)
>  #define KASAN_SHADOW_END       MODULES_LOWEST_VADDR
> +
> +#ifdef CONFIG_KASAN
>  #define KASAN_SHADOW_OFFSET    _AC(CONFIG_KASAN_SHADOW_OFFSET, UL)
>
>  void kasan_init(void);
> diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
> index 2574f6a3b0e7..5b8cdfafb52a 100644
> --- a/arch/riscv/mm/init.c
> +++ b/arch/riscv/mm/init.c
> @@ -27,6 +27,7 @@
>
>  #include <asm/fixmap.h>
>  #include <asm/io.h>
> +#include <asm/kasan.h>
>  #include <asm/numa.h>
>  #include <asm/pgtable.h>
>  #include <asm/sections.h>
> @@ -1488,10 +1489,16 @@ static void __init preallocate_pgd_pages_range(unsigned long start, unsigned lon
>         panic("Failed to pre-allocate %s pages for %s area\n", lvl, area);
>  }
>
> +#define PAGE_END KASAN_SHADOW_START
> +
>  void __init pgtable_cache_init(void)
>  {
>         preallocate_pgd_pages_range(VMALLOC_START, VMALLOC_END, "vmalloc");
>         if (IS_ENABLED(CONFIG_MODULES))
>                 preallocate_pgd_pages_range(MODULES_VADDR, MODULES_END, "bpf/modules");
> +       if (IS_ENABLED(CONFIG_MEMORY_HOTPLUG)) {
> +               preallocate_pgd_pages_range(VMEMMAP_START, VMEMMAP_END, "vmemmap");
> +               preallocate_pgd_pages_range(PAGE_OFFSET, PAGE_END, "direct map");
> +       }
>  }
>  #endif
> --
> 2.40.1
>

As you asked, with
https://lore.kernel.org/linux-riscv/20240514133614.87813-1-alexghiti@xxxxxxxxxxxx/T/#u,
you will be able to remove the usage of KASAN_SHADOW_START.

But anyhow, you can add:

Reviewed-by: Alexandre Ghiti <alexghiti@xxxxxxxxxxxx>

Thanks,

Alex





[Index of Archives]     [KVM Development]     [Libvirt Development]     [Libvirt Users]     [CentOS Virtualization]     [Netdev]     [Ethernet Bridging]     [Linux Wireless]     [Kernel Newbies]     [Security]     [Linux for Hams]     [Netfilter]     [Bugtraq]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux Admin]     [Samba]

  Powered by Linux