Re: [PATCH v3 0/5] Add a vhost RPMsg API

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 2020/5/28 上午2:05, Guennadi Liakhovetski wrote:
v3:
- address several checkpatch warnings
- address comments from Mathieu Poirier

v2:
- update patch #5 with a correct vhost_dev_init() prototype
- drop patch #6 - it depends on a different patch, that is currently
   an RFC
- address comments from Pierre-Louis Bossart:
   * remove "default n" from Kconfig

Linux supports RPMsg over VirtIO for "remote processor" /AMP use
cases. It can however also be used for virtualisation scenarios,
e.g. when using KVM to run Linux on both the host and the guests.
This patch set adds a wrapper API to facilitate writing vhost
drivers for such RPMsg-based solutions. The first use case is an
audio DSP virtualisation project, currently under development, ready
for review and submission, available at
https://github.com/thesofproject/linux/pull/1501/commits
A further patch for the ADSP vhost RPMsg driver will be sent
separately for review only since it cannot be merged without audio
patches being upstreamed first.


Hi:

It would be hard to evaluate this series without a real user. So if possible, I suggest to post the actual user for vhost rpmsg API.

Thanks



Thanks
Guennadi

_______________________________________________
Virtualization mailing list
Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linuxfoundation.org/mailman/listinfo/virtualization




[Index of Archives]     [KVM Development]     [Libvirt Development]     [Libvirt Users]     [CentOS Virtualization]     [Netdev]     [Ethernet Bridging]     [Linux Wireless]     [Kernel Newbies]     [Security]     [Linux for Hams]     [Netfilter]     [Bugtraq]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux Admin]     [Samba]

  Powered by Linux