On 07/15/2013 04:06 PM, Gleb Natapov wrote:
On Mon, Jul 15, 2013 at 03:20:06PM +0530, Raghavendra K T wrote:
On 07/14/2013 06:42 PM, Gleb Natapov wrote:
On Mon, Jun 24, 2013 at 06:13:42PM +0530, Raghavendra K T wrote:
kvm : Paravirtual ticketlocks support for linux guests running on KVM hypervisor
From: Srivatsa Vaddagiri <vatsa@xxxxxxxxxxxxxxxxxx>
trimming
[...]
+
+static void kvm_lock_spinning(struct arch_spinlock *lock, __ticket_t want)
+{
+ struct kvm_lock_waiting *w;
+ int cpu;
+ u64 start;
+ unsigned long flags;
+
+ w = &__get_cpu_var(lock_waiting);
+ cpu = smp_processor_id();
+ start = spin_time_start();
+
+ /*
+ * Make sure an interrupt handler can't upset things in a
+ * partially setup state.
+ */
+ local_irq_save(flags);
+
+ /*
+ * The ordering protocol on this is that the "lock" pointer
+ * may only be set non-NULL if the "want" ticket is correct.
+ * If we're updating "want", we must first clear "lock".
+ */
+ w->lock = NULL;
+ smp_wmb();
+ w->want = want;
+ smp_wmb();
+ w->lock = lock;
+
+ add_stats(TAKEN_SLOW, 1);
+
+ /*
+ * This uses set_bit, which is atomic but we should not rely on its
+ * reordering gurantees. So barrier is needed after this call.
+ */
+ cpumask_set_cpu(cpu, &waiting_cpus);
+
+ barrier();
+
+ /*
+ * Mark entry to slowpath before doing the pickup test to make
+ * sure we don't deadlock with an unlocker.
+ */
+ __ticket_enter_slowpath(lock);
+
+ /*
+ * check again make sure it didn't become free while
+ * we weren't looking.
+ */
+ if (ACCESS_ONCE(lock->tickets.head) == want) {
+ add_stats(TAKEN_SLOW_PICKUP, 1);
+ goto out;
+ }
+
+ /* Allow interrupts while blocked */
+ local_irq_restore(flags);
+
So what happens if an interrupt comes here and an interrupt handler
takes another spinlock that goes into the slow path? As far as I see
lock_waiting will become overwritten and cpu will be cleared from
waiting_cpus bitmap by nested kvm_lock_spinning(), so when halt is
called here after returning from the interrupt handler nobody is going
to wake this lock holder. Next random interrupt will "fix" it, but it
may be several milliseconds away, or never. We should probably check
if interrupt were enabled and call native_safe_halt() here.
Okay you mean something like below should be done.
if irq_enabled()
native_safe_halt()
else
halt()
It is been a complex stuff for analysis for me.
So in our discussion stack would looking like this.
spinlock()
kvm_lock_spinning()
<------ interrupt here
halt()
From the halt if we trace
It is to early to trace the halt since it was not executed yet. Guest
stack trace will look something like this:
spinlock(a)
kvm_lock_spinning(a)
lock_waiting = a
set bit in waiting_cpus
<------ interrupt here
spinlock(b)
kvm_lock_spinning(b)
lock_waiting = b
set bit in waiting_cpus
halt()
unset bit in waiting_cpus
lock_waiting = NULL
----------> ret from interrupt
halt()
Now at the time of the last halt above lock_waiting == NULL and
waiting_cpus is empty and not interrupt it pending, so who will unhalt
the waiter?
Yes. if an interrupt occurs between
local_irq_restore() and halt(), this is possible. and since this is
rarest of rare (possiility of irq entering slowpath and then no random
irq to do spurious wakeup), we had never hit this problem in the past.
So I am,
1. trying to artificially reproduce this.
2. I replaced the halt with below code,
if (arch_irqs_disabled())
halt();
and ran benchmarks.
But this results in degradation because, it means we again go back and
spin in irq enabled case.
3. Now I am analyzing the performance overhead of safe_halt in irq
enabled case.
if (arch_irqs_disabled())
halt();
else
safe_halt();
_______________________________________________
Virtualization mailing list
Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linuxfoundation.org/mailman/listinfo/virtualization
