On Thu, 2011-12-08 at 20:52 +1030, Rusty Russell wrote:
> Here's the patch series I ended up with. I haven't coded up the QEMU
> side yet, so no idea if the new driver works.
>
> Questions:
> (1) Do we win from separating ISR, NOTIFY and COMMON?
> (2) I used a "u8 bar"; should I use a bir and pack it instead? BIR
> seems a little obscure (noone else in the kernel source seems to
> refer to it).
I started implementing it for KVM tools, when I noticed a strange thing:
my vq creating was failing because the driver was reading a value other
than 0 from the address field of a new vq, and failing.
I've added simple prints in the usermode code, and saw the following
ordering:
1. queue select vq 0
2. queue read address (returns 0 - new vq)
3. queue write address (good address of vq)
4. queue read address (returns !=0, fails)
4. queue select vq 1
>From that I understood that the ordering is wrong, the driver was trying
to read address before selecting the correct vq.
At that point, I've added simple prints to the driver. Initially it
looked as follows:
iowrite16(index, &vp_dev->common->queue_select);
switch (ioread64(&vp_dev->common->queue_address)) {
[...]
};
So I added prints before the iowrite16() and after the ioread64(), and
saw that while the driver prints were ordered, the device ones weren't:
[ 1.264052] before iowrite index=1
kvmtool: net returning pfn (vq=0): 310706176
kvmtool: queue selected: 1
[ 1.264890] after ioread index=1
Suspecting that something was wrong with ordering, I've added a print
between the iowrite and the ioread, and it finally started working well.
Which leads me to the question: Are MMIO vs MMIO reads/writes not
ordered?
--
Sasha.
_______________________________________________
Virtualization mailing list
Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linuxfoundation.org/mailman/listinfo/virtualization
