KVM: Vlans not working with vlan hw rx acceleration

[Sucheta Chakraborty <sucheta.chakraborty@xxxxxxxxxx>]

Hi,

Setup info:
(a) Using RHEL6 kvm. (b) Loaded driver on RHEL6 setup.
(c) Created 2 bridges on top of two interfaces.
(d) Assigned these bridges to 2 VMs.
(e) Created vlans in VMs.

Problem:
When vlan acceleration support is enabled in driver, traffic stops b/w VMs on vlan interfaces inside virtual m/c.
Without, vlan acceleration, everything works fine.

Thanks,

Sucheta.

---

This message and any attached documents contain information from QLogic Corporation or its wholly-owned subsidiaries that may be confidential. If you are not the intended recipient, you may not read, copy, distribute, or use this information. If you have received this transmission in error, please notify the sender immediately by reply e-mail and then delete this message.

_______________________________________________
Virtualization mailing list
Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/virtualization