The reset_gpio member of the usb_phy_gen_xceiv_platform_data structure needs the have negative value or phy-generic's probe will fail unless DT is used. 0 is a valid gpio number. This fixes an issue where phy-generic fails to probe with message: "usb_phy_gen_xceiv.0: Error requesting RESET GPIO 0". Signed-off-by: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx> --- drivers/usb/dwc3/dwc3-exynos.c | 1 + drivers/usb/dwc3/dwc3-pci.c | 1 + 2 files changed, 2 insertions(+) diff --git a/drivers/usb/dwc3/dwc3-exynos.c b/drivers/usb/dwc3/dwc3-exynos.c index 8b20c70..28c8ad7 100644 --- a/drivers/usb/dwc3/dwc3-exynos.c +++ b/drivers/usb/dwc3/dwc3-exynos.c @@ -50,6 +50,7 @@ static int dwc3_exynos_register_phys(struct dwc3_exynos *exynos) exynos->usb2_phy = pdev; pdata.type = USB_PHY_TYPE_USB2; + pdata.gpio_reset = -1; ret = platform_device_add_data(exynos->usb2_phy, &pdata, sizeof(pdata)); if (ret) diff --git a/drivers/usb/dwc3/dwc3-pci.c b/drivers/usb/dwc3/dwc3-pci.c index 665686e..f393c18 100644 --- a/drivers/usb/dwc3/dwc3-pci.c +++ b/drivers/usb/dwc3/dwc3-pci.c @@ -52,6 +52,7 @@ static int dwc3_pci_register_phys(struct dwc3_pci *glue) glue->usb2_phy = pdev; pdata.type = USB_PHY_TYPE_USB2; + pdata.gpio_reset = -1; ret = platform_device_add_data(glue->usb2_phy, &pdata, sizeof(pdata)); if (ret) -- 1.8.5.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html