On Fri, Jul 12, 2013 at 06:04:43AM +0200, Marek Vasut wrote: > Hi Peter, > > > On Thu, Jul 11, 2013 at 07:57:19PM +0200, Marek Vasut wrote: > > > Hi Peter, > > > > > > > This patchset adds tested otg id switch function and > > > > vbus connect and disconnect detection for chipidea driver. > > > > And fix kinds of bugs found at chipidea drivers after enabling > > > > id and vbus detection. > > > > > > > > This patch is fully tested at imx6 sabresd platform. > > > > My chipidea repo: https://github.com/hzpeterchen/linux-usb.git > > > > > > > > Changes for v12: > > > > - Rebased greg's usb-next tree (3.10.0-rc7+) > > > > - Split more small patches for single function and fix. > > > > > > I tested the patchset. Here are the results: > > > > > > - VBUS switching > > > > > > I'm no longer getting any ID interrupts at all when I apply the patch > > > below. The board stays in HOST mode all the time. If I configure it as > > > peripheral, it works as peripheral. Note with [1], I was able to switch > > > from Peripheral->Host , not the other way around. > > > > Thanks for your testing. But first, can you have me check > > if your ID wakeup is enabled? > > ID wakeup? How do I check? > See otgsc at controller register, the ID wakeup enable is bit 24. -- Best Regards, Peter Chen -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
