On Wed, Jun 06, 2012 at 09:03:50AM +0300, Felipe Balbi wrote: > On Wed, Jun 06, 2012 at 10:27:22AM +0800, Shawn Guo wrote: > > On Tue, Jun 05, 2012 at 06:02:13PM +0300, Felipe Balbi wrote: > > > Hi, > > > > > > On Fri, May 25, 2012 at 10:24:13AM +0800, Richard Zhao wrote: > > > > The work is based on ci13xxx rework done by Alexander Shishkin. > > > > > > > > Status: > > > > - this version only support host > > > > - usbotg controler works at host role > > > > > > > > Changes since V2: > > > > - Rebase to Alex's tree > > > > - Use regulator to control vbus power > > > > - Remove ARCH check in Kconfig, but add OF_DEV check. > > > > - Other changes according laster version comments. > > > > > > > > Richard Zhao (12): > > > > usb: otg: add notify_connect/notify_disconnect callback > > > > usb: chipidea: permit driver bindings pass phy pointer > > > > usb: ehci-hcd: notify phy when connect change > > > > usb: otg: add basic mxs phy driver support > > > > usb: chipidea: add imx platform driver > > > > ARM: imx6q: correct device name of usbphy and usb controller clock > > > > export > > > > ARM: imx6q: add config-on-boot gpios > > > > ARM: imx6q: add usbphy clocks > > > > ARM: imx6q: disable usb charger detector > > > > ARM: dts: imx6q-sabrelite: add usb devices > > > > ARM: mxs: clk_register_clkdev mx28 usb clocks > > > > ARM: dts: imx28-evk: add usb devices > > > > > > how are we going to handle these series ? drivers/usb/otg/* parts are > > > mostly ok (I need to look deeper) but if I take drivers/usb/otg/* we > > > will have to delay drivers/usb/chipidea I guess... > > > > > > So someone would have to take the whole series ? Who will be that > > > person? Alex, will it be you ? > > > > > I'm unsure about drivers/usb part, but arch/arm part should go via > > arm-soc tree. > > Yes, sure but the whole series is very "coupled" together... Maybe > Richard could try to split this series into things that can go through > arm-soc with no dependency on the other part and things that depend on > drivers/usb/* I'm not clear. How does the ARM part depend on drivers/usb? Shawn maybe could pick the ARM platform part. But the usb driver part is divided into three maintainer, Balbi for otg, Alan for ehci-hcd, Alex for Chipidea. Chipidea part depends on ehci-hcd and otg. So I guess Greg could pick up all the driver part and Balbi, Alan and Alex merge them back. Hope it could avoid loop dependency. Thanks Richard > > Richard, can you do that ? > > -- > balbi -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
