Hi,
On Sun, Jun 3, 2012 at 11:54 PM, Roland Stigge <stigge@xxxxxxxxx> wrote:
> OHCI drivers are supposed to use ohci_finish_controller_resume(). This patch
> adds respective suspend and resume code to ohci-nxp. The following compiler
> warning is fixed this way:
>
> drivers/usb/host/ohci-hub.c:321: warning: 'ohci_finish_controller_resume'
> defined but not used
>
> Signed-off-by: Roland Stigge <stigge@xxxxxxxxx>
>
> ---
> Applies to v3.5-rc1
>
> drivers/usb/host/ohci-nxp.c | 21 +++++++++++++++++++++
> 1 file changed, 21 insertions(+)
>
> --- linux-2.6.orig/drivers/usb/host/ohci-nxp.c
> +++ linux-2.6/drivers/usb/host/ohci-nxp.c
> @@ -432,6 +432,23 @@ static int usb_hcd_nxp_remove(struct pla
> return 0;
> }
>
> +#ifdef CONFIG_PM
> +static int usb_hcd_suspend(struct platform_device *pdev, pm_message_t message)
> +{
> + clk_disable(usb_clk);
> + return 0;
> +}
> +
> +static int usb_hcd_resume(struct platform_device *pdev)
> +{
> + struct usb_hcd *hcd = platform_get_drvdata(pdev);
> +
> + clk_enable(usb_clk);
> + ohci_finish_controller_resume(hcd);
> + return 0;
> +}
> +#endif
> +
> /* work with hotplug and coldplug */
> MODULE_ALIAS("platform:usb-ohci");
>
> @@ -451,5 +468,9 @@ static struct platform_driver usb_hcd_nx
> },
> .probe = usb_hcd_nxp_probe,
> .remove = usb_hcd_nxp_remove,
> +#ifdef CONFIG_PM
> + .suspend = usb_hcd_suspend,
> + .resume = usb_hcd_resume,
> +#endif
Please make use of the SET_SYSTEM_SLEEP_PM_OPS() initializer.
Thanks
Kishon
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
