gpmc code has been converted to driver. Modify the board
code to provide gpmc driver with required information.
Signed-off-by: Afzal Mohammed <afzal@xxxxxx>
---
arch/arm/mach-omap2/board-n8x0.c | 18 +++++++++++++++---
1 file changed, 15 insertions(+), 3 deletions(-)
diff --git a/arch/arm/mach-omap2/board-n8x0.c b/arch/arm/mach-omap2/board-n8x0.c
index 94f6077..d3d866a 100644
--- a/arch/arm/mach-omap2/board-n8x0.c
+++ b/arch/arm/mach-omap2/board-n8x0.c
@@ -36,6 +36,7 @@
#include <plat/onenand.h>
#include <plat/mmc.h>
#include <plat/serial.h>
+#include <plat/gpmc.h>
#include "mux.h"
@@ -45,6 +46,13 @@
#define TUSB6010_GPIO_ENABLE 0
#define TUSB6010_DMACHAN 0x3f
+static struct gpmc_device_pdata *gpmc_device_data[2];
+static struct gpmc_device_pdata **gpmc_cur = gpmc_device_data;
+
+static struct gpmc_pdata gpmc_data = {
+ .device_pdata = gpmc_device_data,
+};
+
#if defined(CONFIG_USB_MUSB_TUSB6010) || defined(CONFIG_USB_MUSB_TUSB6010_MODULE)
/*
* Enable or disable power to TUSB6010. When enabling, turn on 3.3 V and
@@ -114,10 +122,12 @@ static void __init n8x0_usb_init(void)
}
tusb_set_power(0);
- ret = tusb6010_setup_interface(&tusb_data, TUSB6010_REFCLK_19, 2,
+ *gpmc_cur = tusb6010_setup_interface(&tusb_data, TUSB6010_REFCLK_19, 2,
TUSB6010_ASYNC_CS, TUSB6010_SYNC_CS,
TUSB6010_GPIO_INT, TUSB6010_DMACHAN);
- if (ret != 0)
+ if (*gpmc_cur)
+ gpmc_data.num_device++, gpmc_cur++;
+ else
goto err;
printk(announce);
@@ -785,7 +795,9 @@ static void __init n8x0_init_machine(void)
ARRAY_SIZE(n810_i2c_board_info_2));
board_serial_init();
omap_sdrc_init(NULL, NULL);
- gpmc_onenand_init(board_onenand_data);
+ *gpmc_cur++ = gpmc_onenand_init(board_onenand_data);
+ gpmc_data.num_device++;
+ omap_init_gpmc(&gpmc_data);
n8x0_mmc_init();
n8x0_usb_init();
}
--
1.7.10
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
