On 03/31/2012 11:51 PM, Sergei Shtylyov :
> Hello.
>
> On 29-03-2012 17:27, Nicolas Ferre wrote:
>
>> Due to an error while handling vbus_pin_active_low in ohci-at91 driver,
>> the specification of this property was not good in devices/board files.
>
>> Signed-off-by: Nicolas Ferre<nicolas.ferre@xxxxxxxxx>
>> Acked-by: Jean-Christophe PLAGNIOL-VILLARD<plagnioj@xxxxxxxxxxxx>
>> Cc: stable<stable@xxxxxxxxxxxxxxx> [3.2+]
>> ---
>> arch/arm/mach-at91/at91sam9263_devices.c | 3 ++-
>> arch/arm/mach-at91/at91sam9g45_devices.c | 6 ++++--
>> arch/arm/mach-at91/board-sam9263ek.c | 1 +
>> arch/arm/mach-at91/board-sam9m10g45ek.c | 1 +
>> 4 files changed, 8 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm/mach-at91/at91sam9263_devices.c
>> b/arch/arm/mach-at91/at91sam9263_devices.c
>> index 53688c4..5cdca89d 100644
>> --- a/arch/arm/mach-at91/at91sam9263_devices.c
>> +++ b/arch/arm/mach-at91/at91sam9263_devices.c
>> @@ -72,7 +72,8 @@ void __init at91_add_device_usbh(struct
>> at91_usbh_data *data)
>> /* Enable VBus control for UHP ports */
>> for (i = 0; i< data->ports; i++) {
>> if (gpio_is_valid(data->vbus_pin[i]))
>> - at91_set_gpio_output(data->vbus_pin[i], 0);
>> + at91_set_gpio_output(data->vbus_pin[i],
>> + data->vbus_pin_active_low[i] ^ 0);
>
> Note that XOR with 0 is a nop, left operand doesn't change its value.
Sure I will correct that.
Thanks, best regards,
--
Nicolas Ferre
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
