On Wed, Dec 7, 2011 at 2:40 PM, Grant Grundler <grundler@xxxxxxxxxxxx> wrote: > Hi, > I'm testing asix (USB 100BT ethernet adapter with AX88772) driver > initialization (and shut down) paths and reproduced a > "skb_queue_purge" panic 3 times after a few hundred/thousand > iterations of rmmod/modprobe. I'm inclined to believe > skb_queue_purge() is a victim and not a culprit here. FYI - Follow up: I'm not able to reproduce this problem in 10000 iterations of unload/USB off/USB on/load asix cycles. I've closed the original bug report (http://crosbug.com/17349). Our kernel moved forward to 3.0.13 since then (was 3.0.8 based) but I'm skeptical this 'fixed' the problem. So I think there is something else going on (memory corruption? don't know). cheers, grant > > I don't know if all 3 "spontaneous reboots" I've seen have the same > stack trace as the one I have a record for: > > ... > <6>[57776.637311] asix 1-4:1.0: eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1 > <6>[57777.224552] usbcore: deregistering interface driver asix > <6>[57777.224859] asix 1-4:1.0: eth0: unregister 'asix' > usb-0000:00:1d.7-4, ASIX AX88772 USB 2.0 Ethernet > <1>[57777.224918] BUG: unable to handle kernel NULL pointer > dereference at 00000002 > <1>[57777.224934] IP: [<00000002>] 0x1 > <5>[57777.224952] *pdpt = 0000000061d70001 *pde = 0000000000000000 > <0>[57777.224967] Oops: 0010 [#1] SMP > <5>[57777.224980] Modules linked in: asix(-) i2c_dev tsl2583(C) > industrialio(C) snd_hda_codec_realtek i2c_i801 nm10_gpio snd_hda_intel > snd_hda_codec snd_hwdep snd_pcm snd_timer snd_page_alloc gobi rtc_cmos > fuse nf_conntrack_ipv6 nf_defrag_ipv6 ip6table_filter xt_mark ath9k > ip6_tables mac80211 ath9k_common ath9k_hw ath cfg80211 uvcvideo > videodev usbnet qcserial usb_wwan [last unloaded: asix] > <5>[57777.225109] > <5>[57777.225121] Pid: 30292, comm: rmmod Tainted: G C 3.0.8 > #2 SAMSUNG ELECTRONICS CO., LTD. Alex/G100 > <5>[57777.225141] EIP: 0060:[<00000002>] EFLAGS: 00010286 CPU: 1 > <5>[57777.225153] EIP is at 0x2 > <5>[57777.225162] EAX: 00000001 EBX: 00000100 ECX: 00000000 EDX: 00000100 > <5>[57777.225172] ESI: f6bad5a8 EDI: f6bad59c EBP: e44e7e20 ESP: e44e7e14 > <5>[57777.225183] DS: 007b ES: 007b FS: 00d8 GS: 00e0 SS: 0068 > <0>[57777.225194] Process rmmod (pid: 30292, ti=e44e6000 task=f0c2e040 > task.ti=e44e6000) > <0>[57777.225203] Stack: > <5>[57777.225209] f58fdb70 f6bad000 f8c63a34 e44e7e2c 812d2a98 > f6bad480 e44e7e40 f87e820e > <5>[57777.225242] e44e7e88 f6bad000 e44e7e88 e44e7e50 812d79cd > e44e7e88 f6bad000 e44e7e6c > <5>[57777.225273] 812d7a82 e44e7e58 e44e7e58 e44e7e88 f6bad000 > e44e7e88 e44e7e80 812d7b60 > <0>[57777.225305] Call Trace: > <5>[57777.225325] [<812d2a98>] skb_queue_purge+0x19/0x20 > <5>[57777.225345] [<f87e820e>] usbnet_stop+0xb5/0xf9 [usbnet] > <5>[57777.225361] [<812d79cd>] __dev_close_many+0x85/0xa2 > <5>[57777.225375] [<812d7a82>] dev_close_many+0x61/0xb1 > <5>[57777.225390] [<812d7b60>] rollback_registered_many+0x8e/0x1ec > <5>[57777.225405] [<812d9224>] unregister_netdevice_queue+0x6e/0x9f > <5>[57777.225419] [<812d9270>] unregister_netdev+0x1b/0x22 > <5>[57777.225437] [<f87e76be>] usbnet_disconnect+0x71/0xb9 [usbnet] > <5>[57777.225454] [<81273a03>] usb_unbind_interface+0x44/0xf8 > <5>[57777.225471] [<81237d25>] __device_release_driver+0x80/0xb8 > <5>[57777.225484] [<812381e2>] driver_detach+0x6c/0x8a > <5>[57777.225499] [<81237c41>] bus_remove_driver+0x6e/0x8d > <5>[57777.225513] [<81238721>] driver_unregister+0x51/0x58 > <5>[57777.225526] [<812730c2>] usb_deregister+0x92/0x9f > <5>[57777.225541] [<f8c62885>] cleanup_module+0xd/0x788 [asix] > <5>[57777.225556] [<810573ed>] sys_delete_module+0x19d/0x1fa > <5>[57777.225573] [<8109a059>] ? do_munmap+0x1f2/0x20a > <5>[57777.225590] [<8137e677>] sysenter_do_call+0x12/0x26 > <0>[57777.225599] Code: Bad EIP value. > <0>[57777.225614] EIP: [<00000002>] 0x2 SS:ESP 0068:e44e7e14 > <0>[57777.225631] CR2: 0000000000000002 > <1>[57777.225035] BUG: unable to handle kernel NULL pointer > dereference at (null) > <1>[57777.225035] IP: [< (null)>] (null) > <5>[57777.225035] *pdpt = 000000006ff81001 *pde = 0000000000000000 > <4>[57777.225684] ---[ end trace > > > On my workstation, I run the following to push/run multiple iterations > on the target system: > T=root@xxxxxxxxxxxx > scp ~/reload_asix $T:/tmp > for i in `seq 10000`; do printf " %3d: " $i; ssh $T ". > /tmp/reload_asix" && ssh $T "tail -30 /var/log/messages | fgrep > leased" ; done | tee reload_asix-loop.out > > > "/tmp/reload_asix" script has the following contents: > #!/bin/bash -x > > # redirect all output to a file. SSH might drop. > exec > /tmp/`date --rfc-3339=date`-reload-$$.out 2>&1 > > date > rmmod asix > > # side effect of auth/deauth is a USB reset on reconnect. :) > echo 0 > /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-4/authorized > sleep 1 > echo 1 > /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-4/authorized > sleep 1 > > time modprobe asix > > for i in `seq 5` ; do > l="$(cat /sys/class/net/eth0/speed) $(cat /sys/class/net/eth0/duplex)" > printf "%3d: %s %s\n" $i $(cat /sys/class/net/eth0/address) "$l" > if [ "$l" = "100 full" ] ; then > break > fi > sleep 1 > done > > # at this point we have negotiated link..but not DHCP yet. :/ > return 0 > > > Reproduced this panic on two different x86 laptops (Asus AGB and > Samsung Series 5). > > At first glance, this doesn't look like an asix driver bug (though it might be). > I'm hoping the bug will be obvious to someone who understands usbnet > and skb_queue calls. > Open to any debugging advice folks have. > > thanks in advance, > grant -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
