On Fri, 6 Jan 2012, Alessandro Rubini wrote:
> Signed-off-by: Alessandro Rubini <rubini@xxxxxxxxx>
> Acked-by: Giancarlo Asnaghi <giancarlo.asnaghi@xxxxxx>
> Cc: Alan Cox <alan@xxxxxxxxxxxxxxx>
> ---
> drivers/usb/host/ehci-pci.c | 6 ++++++
> drivers/usb/host/ohci-pci.c | 4 ++++
> 2 files changed, 10 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/usb/host/ehci-pci.c b/drivers/usb/host/ehci-pci.c
> index f4b627d..01bb7241d 100644
> --- a/drivers/usb/host/ehci-pci.c
> +++ b/drivers/usb/host/ehci-pci.c
> @@ -276,6 +276,9 @@ static int ehci_pci_setup(struct usb_hcd *hcd)
>
> /* Serial Bus Release Number is at PCI 0x60 offset */
> pci_read_config_byte(pdev, 0x60, &ehci->sbrn);
> + if (pdev->vendor == PCI_VENDOR_ID_STMICRO
> + && pdev->device == PCI_DEVICE_ID_STMICRO_USB_HOST)
> + ehci->sbrn = 0x20; /* ConneXT has no sbrn register */
>
> /* Keep this around for a while just in case some EHCI
> * implementation uses legacy PCI PM support. This test
> @@ -526,6 +529,9 @@ static const struct pci_device_id pci_ids [] = { {
> /* handle any USB 2.0 EHCI controller */
> PCI_DEVICE_CLASS(PCI_CLASS_SERIAL_USB_EHCI, ~0),
> .driver_data = (unsigned long) &ehci_pci_hc_driver,
> + }, {
> + PCI_VDEVICE(STMICRO, PCI_DEVICE_ID_STMICRO_USB_HOST),
> + .driver_data = (unsigned long) &ehci_pci_hc_driver,
> },
> { /* end: all zeroes */ }
> };
> diff --git a/drivers/usb/host/ohci-pci.c b/drivers/usb/host/ohci-pci.c
> index 6109810..1843bb6 100644
> --- a/drivers/usb/host/ohci-pci.c
> +++ b/drivers/usb/host/ohci-pci.c
> @@ -397,6 +397,10 @@ static const struct pci_device_id pci_ids [] = { {
> /* handle any USB OHCI controller */
> PCI_DEVICE_CLASS(PCI_CLASS_SERIAL_USB_OHCI, ~0),
> .driver_data = (unsigned long) &ohci_pci_hc_driver,
> + }, {
> + /* The device in the ConneXT I/O hub has no class reg */
> + PCI_VDEVICE(STMICRO, PCI_DEVICE_ID_STMICRO_USB_OHCI),
> + .driver_data = (unsigned long) &ohci_pci_hc_driver,
> }, { /* end: all zeroes */ }
> };
> MODULE_DEVICE_TABLE (pci, pci_ids);
Acked-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
Why doesn't the ConneXT implement the required PCI registers?
Alan Stern
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
